00900068-02_SM_ASM_ProcessLens_EN - 第73页

ASM Proces sLens Single - l ane 03/2020 Edit ion 73 Step 5 Move the c amer a head m odule to the left f or easy ac cess. 1. Gentl y pull out l ow ring light connector b y holding onto the connec tor´s bo dy. Do not pull …

100%1 / 92
ASM ProcessLens Single-lane 03/2020 Edition
72
Step 4
Install the Coaxial Light assembly onto the camera module as shown below.
1. Place the bracket over the
camera ring frame.
2. Attach the coaxial lighting
assembly from below the
camera ring frame to the
bracket above the ring
frame with the 2 screws.
The camera ring frame is
sandwiched by this
assembly.
3. Tighten the 2 screws.
The coaxial light assembly
should be secured to the
camera ring light frame with
no movement.
4. The circular protrusion at the
bottom side of the bracket should
sit face down snugly inside the
ling light assembly.
ASM ProcessLens Single-lane 03/2020 Edition
73
Step 5
Move the camera head module to the left for easy access.
1. Gently pull out low ring light
connector by holding onto
the connector´s body. Do
not pull using the wires.
Use a flat fead screwdrive
to pry if necessary.
2. Plug-in the coaxial light
cable.
3. Secure the coaxial light
cable with cable ties to
prevent flapping when the
cameras move.
Step 6
1.
Put in the mapping plate.
2.
Refer to bottom left hand corner
of the plate. The arrows on the
long side is pointing towards the
left and the arrows on the short
side of the plate is pointing
towards the front.
3.
Leading edge.
4.
Pull the sensor bar to the front
and position under the leading
aluminium edge of the plate.
ASM ProcessLens Single-lane 03/2020 Edition
74
Step 7
1.
Clean the mapping plate using a
piece of lint free cloth and alcohol.
Dust and fingerprints can distort
images and cause the mapping to
fail.
2.
Align the left edge of the mapping
plate to the left edge of the
conveyor´s front top clamp.
Step 8
1.
Close the machine cover.
2.
Click OK. The machine locks the
cover, the table raises to clamp
the plate, and th
e camera starts to
move to the bottom right corner of
the plate.
Step 9
1.
The plate´s bottom right hand
cross fiducial comes into view.
Click on the cross to centre the
cross to the FOV.
2.
Set 2D M-Ring_G light between
10 ~ 20 (recommend 15) and all
other lighting values to 0.