00193360-02 - 第28页

Retrofitting Instructions Splice Detection B asic Package S /F 11/2003 Edition 28 : Pull the cable further to the opening between the power su pply dr awer unit and the machi ne frame (Fig. 7 - 6). 17 Fig. 17 - 6 Diagram…

Retrofitting Instructions Splice Detection Basic Package S/F

11/2003 Edition

17.2 Connecting location 3 to the HUB

: Check once again that you have disconnected the station from the power supply.

: Remove the cover from the power supply unit.

First detach the grounding cable fixed to the inside of the cover. 17

: Remove the screw that secures the power supply unit, and pull the unit out of its drawer care-

fully.

: Loosen the 6 screws to remove the U-profile at location 3.

: Then fix the narrow end of the cable to the pilot wire, and pull it as far as the opening on the Y

axis motor (as for the connection for location 1).

: Replace the U-profile (panel) with the U-profile supplied (which has the additional opening for

the socket for connecting the splice detector).

: Fix the cable to the HUB using the 4x M3 screws provided.

Retrofitting Instructions Splice Detection Basic Package S/F

11/2003 Edition

: Pull the cable further to the opening between the power supply drawer unit and the machine

frame (Fig. 7 - 6).

Fig. 17 - 6 Diagram of the cable route to location 3

: Pull the cable through the machine to the opening in the servo drawer unit, and on to the hub

(as for the connection for location 1).

: Fix the new U-profile at the machine.

Retrofitting Instructions Splice Detection Basic Package S/F

11/2003 Edition

18 Power Supply for the HUB Unit

Fig. 18 - 1 Connecting the power supply for the hub

: Start at terminal block X212 (Fig. 8 - 1)

: Connect the voltage terminals as shown in Fig. 8 - 2.

: Connect the first wire (white or blue) of power supply cable to a GND terminal.

: Connect the brown wire to a +15 V terminal.

. 18

Fig. 18 - 2 Terminals for power supply

: Run the cable through the existing cable ducts to the hub.