CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第28页

Samsung Component Placer CP45NEO Series Maintenance Refer ence (Based on CE Machine) Main Circuit Breaker  Noise Filter Refers to an electric device that allows el ectrical current to flow stably by preventing any disto…

Preface

Stage Camera Ass’y

Flying

Camer

Flying

Camera

Illumination

 Solenoid Valve

Refers to an electronic valve that is electrically opened and closed, which is

connected to the electromagnet of the solenoid.

 Blow Chamber

Attenuates the thundering sound generated when the pneumatic device (solenoid) is

operated by the pneumatic pressure supplied to the machine to an appropriate level.

 Current Breaker

Breaks the circuit when an abnormally large current flows through the circuit as the

result of a fault, such as in the case of a short circuit.

 Air Filter

Refers to a device that removes any dust suspended in the air.

 Auto Drainer

Refers to a device that automatically discharges the water collected in the air filter.

 Grease Gun

Refers to a device that supplies grease.

 Nipple Tip

Refers to a type of connection that is connected to the grease gun. The types of nipple

tips vary according to the shape of the grease nipple.

 Main Circuit Breaker

Located at the bottom left of the rear side of the machine, it switches on or off the

main power supplied to the machine.

Samsung Component Placer CP45NEO Series Maintenance Reference

(Based on CE Machine)

Main Circuit

Breaker

 Noise Filter

Refers to an electric device that allows electrical current to flow stably by preventing

any distortion of the current wave generated in the circuit.

 F.G(Frame Ground)

Refers to the point at which the machine is grounded.

F.G

xvi

Preventive Maintenance

Chapter 1 . Preventive Maintenance

1-1

1.1. Maintenance Procedure(ce model)

The following procedures should be performed before doing any maintenance task.

1. Check to see if all the operations of the equipment are terminated.

2. Turn off the Isolation Switch.

3. Turn off the Main Circuit Breaker.

4. Perform the maintenance tasks according to the directions explained in the following

sections. .

After completing the maintenance tasks, please follow the procedures outlined below in

order to operate the equipment properly.

1. Check to see if there are any abnormal substances in the maintenance area, and if any,

remove them.

2. Make sure that all the parts are re-assembled properly.

3. Turn on the Main Circuit Breaker.

4. Turn on the power of the equipment according to the procedures mentioned in power

inspection.

5. Confirm that the equipment is operated normally without any problem.

Warning

Please turn off the Main Switch in the right lower cover of

rear side before performing any maintenance related tasks.

Loss of human life may occur if proper safety measures are

not taken.

Main Switch

OFF