CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第58页

Samsung Component Placer CP45NEO Series Maintenance Refer ence  Assembling is done in the reverse order . 3.1.3. S pindle Inspection Contamination (such as solder paste, etc.) in the spindle can cause pickup probl ems. …

Weekly Inspection

3-7

spanner clockwise, and supply air pressure through the connection hose.

 Lay a clean cloth at the bottom of the nozzle holder of head 01 and blow out

repeatedly by pressing the manual switch of So1 ten times.

 Blow out head 02 to head 06 in the same way.

 According to the state of the impurities collected on the cloth, remove the vacuum

filter and clean or replace it every two months.

Samsung Component Placer CP45NEO Series Maintenance Reference

 Assembling is done in the reverse order.

3.1.3. Spindle

Inspection

Contamination (such as solder paste, etc.) in the spindle can cause pickup problems. The

inside of the spindle must be cleaned in case of contamination. Perform the cleaning of

the spindle and vacuum filter at the same time.

Spindle

3-8

Weekly Inspection

3-9

Solution

 After blowing the ‘3-4 vacuum filter’ first, turn the rotary fitting on the upper part of

the spindle counterclockwise using a 6mm spanner, and inject adequate quantity of

alcohol from the cleaning kit before assembling.

 Be sure to put a soft cloth on the hole under the spindle to catch any alcohol that

splashes, and completely blow out the alcohol and other impurities remaining inside

using an air gun.

Caution

Using the air gun without putting on goggles may cause injury

to the eyes of the operator. Be sure to wear goggles when

using the air gun.

 After assembling the rotary fitting, Assemble the vacuum filter referring to the

vacuum filter cleaning procedure.

 If problems with the vacuum generation still occur even after cleaning the filter,

contact our designated C/S company (STS) and local agent.

3.1.4. X-Y Frame

Inspection

 Check the wear of the cableveyor wrapping the major cable assembly and air hose of

the X frame and Y1 frame. In case of damage or wear in the cableveyor, there may be

noise in the machine and damages in the cable assembly and air hose.