CP45FVNEO Maintenance Reference (Eng, Ver3).pdf - 第88页
在线预览 CP45FVNEO Maintenance Reference (Eng, Ver3).pdf PDF 文档。
Weekly Inspection
3-37
If abnormal noise and operational problem still occur, turn off the main switch of the
machine again and replace the cooling fan
Assembling is done in the reverse order.
Warning
The cooling fan replacement work accompanies a danger.
Therefore, contact our C/S company or local agent.
3.2.9. Lubrication and Grease Application
For details relating to the lubrication and grease application, refer to “Chapter 4 .
Lubricant Method (page 4-1)”.
Caution
Since the lubrication and grease application for the
machine is critical to the lifetime of the machine, ensure
that periodical lubrication and grease application are
performed.
Lubricant Method
Chapter 4 . Lubricant Method
4-1
4.1. Component Lubrication
Table 4-1. Table of Component Lubrication
Major Category Sub Category Lubricant Type Maker Method Period
L/M Guide Grease(EP2) SHELL Grease Gun Every Four Months
Head
Ball Spline
ALVANIA
EP GREASE 2
SHELL Apply Grease Every Three Months
L/M Guide Grease(EP2) SHELL Apply Grease Every Month
X-axis
Ball Screw Grease(G-142K) Kanto Kasei Apply Grease Every Month
Grease(EP2) SHELL Grease Gun Every Three Months
L/M Guide
Grease(EP2) SHELL Apply Grease Every Month
Grease(G-142K) Kanto Kasei Grease Gun Every Three Months
Y-axis
Ball Screw
Grease(G-142K) Kanto Kasei Apply Grease Every Month
Lead Screw Grease(G-142K) Kanto Kasei Apply Grease Every Two Months
L/M Guide Rail Grease(EP2) SHELL Apply Grease Every Six Months
Conveyor
Width
Adjustment
Chain
Grease(EP2) SHELL Apply Grease Every Years
Grease(EP2): Li Compl. soap grease no.2.
Caution
Grease specifications (EP2, G-142K)
Type : Lithium soap, high load (industrial purpose), lithium complex, and non leaded
Cone Penetration: 265-295 (NLGI Grade No. 2), Temperature range: -15 / +150 ℃
(Dropping point: 255℃)
Purchase information: Kihung Trading Co. (KANTO KASEI Sales representative in
Busan (T.051-808-3549)).
Available in the unit of 15kg(1 mal).
Application method
In principle, apply or inject once every 100km of operation.
Inject or apply once every 1~2 weeks (If the machine is operated 24 hours a day)
Inject or apply once a month (If the machine is operated 10 hours a day)
Injection method
Check the grease gun. Do not mix it with other grease.
Inject through the grease nipple by using the Grease Gun. (Recommended injection
amount: 5g / per injection for one block)
Inject grease while moving the gantry slowly as it might not reach the rolling bearing
if it is injected while the LM Block is stationary. (Y axis)