00197569-01_MM_DLM34_Kunde_en - 第24页
Minor Maintenance Maintenance Tasks for DLM 3.1.4 Performing Maintenance Tasks 24 Maintenance Manual SIPLACE Placement Heads DLM3/DLM4 ► Remove the dirt from the longitudinal vacuum hole by turning the 1.4 mm drill bit c…
Minor Maintenance
3.1.4 Performing Maintenance Tasks Maintenance Tasks for DLM
Maintenance Manual SIPLACE Placement Heads DLM3/DLM4 23
3.1.4.7
3.1.4.7 Checking, Cleaning and Greasing the Sleeves
Checking, Cleaning and Greasing the Sleeves
► Check the foil for damage.
If the foil is damaged, send the sleeve to the
SIPLACE Sleeve Maintenance team.
► (1) Spray a little Teflon grease into a suitable vessel.
► (2) Moisten the cottonwool bud with Teflon grease.
CAUTION!
Do not spray Teflon grease directly onto the cottonwool
buds with the spray can. Using a separate vessel helps to
avoid excess application and consequential damage to
the placement head!
Always use either ethanol or Isopropanol for cleaning
purposes. Do not use white spirit, otherwise streaks will
form on the incremental disk!
Do not use silicon-soluble cleaning agents.
► (3) Run the dampened cottonwool bud along the
groove of the anti-rotation element.
► (1) Check that the switching ring moves easily in the
sleeve. The unit that is moved as a result must not
stick or grate. However, if still does stick or grate, de
-
spite greasing, send the sleeve to the SIPLACE
Sleeve Maintenance team.
► Repeat these steps for all sleeves.
Minor Maintenance
Maintenance Tasks for DLM 3.1.4 Performing Maintenance Tasks
24 Maintenance Manual SIPLACE Placement Heads DLM3/DLM4
► Remove the dirt from the longitudinal vacuum hole by
turning the 1.4 mm drill bit clockwise in the hole. Turn
-
ing the bit will remove the dirt from the hole.
► Use the same procedure to remove the dirt from the
transverse vacuum hole using the 1.1 mm drill bit.
► Wear laboratory gloves for this step.
► (1) Check the suction plate for damage. If it is dam
-
aged, replace it.
► (2) Clean the sleeve suction plate using a dry, lint-
free cloth.
► Clean the edge (1) of the sleeve with a lint-free cloth,
moistened with ethanol.
► Clean the incremental disk (2) of the sleeve with a
lint-free cloth, moistened with ethanol.
Minor Maintenance
3.1.4 Performing Maintenance Tasks Maintenance Tasks for DLM
Maintenance Manual SIPLACE Placement Heads DLM3/DLM4 25
► Clean the sleeve shaft (1) with a lint-free cloth, mois
-
tened with ethanol.
► Carefully clean the circumference (2) of the ball catch
with a cottonwool bud moistened with ethanol.