00196014-0102_AI_PCI_KarteAuteRecoveryFunktionX4i_DE EN - 第15页

PCI card 2 Assembly Instructions PCI Card for SIPLACE X4I Auto Recovery Function 12/2007 Edition 15 2.6 Inst alling the AutoRecovery card : Shut down the placement ma chine and switch it off at the main switch. 2 : Open …

100%1 / 22
2 Assembly Instructions PCI Card for SIPLACE X4I Auto Recovery Function PCI card
12/2007 Edition
14
2.5 Safety instructions
WARNING
The safety instructions from the "Operational safety" chapter
of the user manual and servicing in-
structions take precedence over these instru
ctions. 2
The SIPLACE placement machines are supplied with main power voltage.
Consequently parts of these systems carry dangerous voltages! This v
oltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or sever
e injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly,
then switch the machine
OFF at the main power switch and disconnect from the mains power supply. In addition, the com-
pressed air supply must be switched off at the compressed
air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicini
ty of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or oth
er standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Op
erational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
D
uring the retrofit, always secure the machine to p
revent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2.5.1 Definitions
2
Please note 2
2
2
2
Caution 2
PCI card 2 Assembly Instructions PCI Card for SIPLACE X4I Auto Recovery Function
12/2007 Edition
15
2.6 Installing the AutoRecovery card
: Shut down the placement machine and switch it off at the main switch.
2
: Open the safety door to the computer unit and remove it.
: Loosen the fixing screw on the left of the computer unit.
: Pull the unit
o
ut slowly and put it down on the floor carefully.
2
The computer unit is very heavy. 2
Watch out for the wiring harness! 2
Computer unit
2
2
2
2
2
2
2 Assembly Instructions PCI Card for SIPLACE X4I Auto Recovery Function PCI card
12/2007 Edition
16
: Loosen the fixing screws on the bottom BoxPC (see photograph).
: Detach the cables from the lower BoxPC.
Bottom BoxPC
2 fixing screws on each side
2
2
: Pull out the BoxPC carefully and place it on a flat surface.
2
2
2
2
2
2
2
2
2