00198142-01_AI_Stationary-Camera-25-33_TX_de_en - 第77页
Installation Fitting the Stationary Camera Type SST33 Stationary Camera Typ e 25/33 Stationäre Kamera Typ 25/33 77 3.4 3 . 4 F it t in g t h e S t a t io n a r y C a m e r a T y p e S S T 3 3 Fitting the Stationary Camer…
Installation
Fitting the Stationary Camera Type SST25
76 Stationary Camera Type 25/33 Stationäre Kamera Typ 25/33
Putting on the Upper Part and Checking the Installation Height
NOTE: The upper section of the camera is assigned specifically to the lower section of the camera!
NOTICE
The upper section of the camera is assigned specifically to the lower section of the camera!
The upper section of the camera may not be used with a different bottom section. Both the up
-
per and lower sections are mechanically and electrically coordinated and may not be ex
-
changed for use with other cameras. The serial and version numbers of the top and bottom
sections of the camera must be identical.
Putting on the Upper Part and Checking the Installation
Height
► Put the upper part (1) on the basic unit.
► Check the installation height. The support plate and
the upper part must be below the top edge of the con
-
veyor rail.
Installation
Fitting the Stationary Camera Type SST33
Stationary Camera Type 25/33 Stationäre Kamera Typ 25/33 77
3.4
3.4 Fitting the Stationary Camera Type SST33
Fitting the Stationary Camera Type SST33
This section describes the installation of a stationary camera of type SST33 GigE.
For installing a stationary camera of type SST25 GigE, refer to section "3.3 Fitting the Stationary Camera
Type SST25" [ ➙ 73].
Setting the DIP Switches
Fitting the Basic Camera Unit
Setting the DIP Switches
► Set the DIP switches (1):
S1.1 to S1.5: OFF
S1.6: ON
(See also "4.2.1.2 Vision LED Controller VLC33 GigE
DTC [03117981-xx]" [ ➙ 88]).
Screwing in the screws
► Loosely screw in the upper screws (1).
(ISO4762-M6x25-A2-70 [03042575
-
xx])
Use the outer bottom screw positions.
Installation
Fitting the Stationary Camera Type SST33
78 Stationary Camera Type 25/33 Stationäre Kamera Typ 25/33
Hooking in the basic camera unit
► Place the basic camera unit at its installation position
from above.
► Hook the basic camera unit on the two screws (1) us
-
ing the upper keyholes.
Checking the installation height
► Check the installation height of the camera. The cam
-
era must be fitted to the lowest position I (1).
► Screw two more screws (2) ISO4762-M6x25-A2-70
[03042575
-
xx] into the lower keyholes.
► Screw all four screws (1) and (2) tight.