192866 Issue 4 - Reel to Reel Manual LoRes - 第21页

TECHNICAL REFERENCE ADJUSTMENTS AND SETTINGS Chapter Issue 1, Apr 15 Reel to Reel Manual 1.11 8. Using a 2mm Allen key , loosen the two grub screws that secure the right hand pulley to the drive shaf t. 9. Repeat for the…

100%1 / 40
TECHNICAL REFERENCE
ADJUSTMENTS AND SETTINGS
1.10 Reel to Reel Manual Chapter Issue 1, Apr 15
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
3. To move the position of a belt, slip the belt off the left and right belt pulleys.
4. Using a 3mm Allen key, remove the four belt clamp securing screws (two on
the right hand side of the inner transport vacuum plate and two on the left
hand side).
5. Fit the belt clamps to the new positions.
6. Fit the belt ends into the belt clamps ensuring the correct amount of belt is
protruding out of the bottom of the clamp, see table below:
7. Tighten the belt clamps.
Belt Position Dimension
Middle Belt 20mm below the clamp
Rear Belt 15mm below the clamp
TECHNICAL REFERENCE
ADJUSTMENTS AND SETTINGS
Chapter Issue 1, Apr 15 Reel to Reel Manual 1.11
8. Using a 2mm Allen key, loosen the two grub screws that secure the right
hand pulley to the drive shaft.
9. Repeat for the left hand pulley.
10. The pulleys must be aligned to the belt clamp position and the measurement
for the belt pulley is referenced from the centre of the pulley in Position 1.
11. Using a steel rule and measuring from the top of the belt on the pulley in
Position 1, use the table below to position the centre of the right hand pulley.
12. Tighten the two pulley grub screws.
13. Repeat Steps 11 and 12 for the left hand pulley.
14. Hook the belt over the left and right hand pulleys.
15. Repeat this procedure for any other belts that require repositioning.
Belt Position Dimension
2 42mm
3 84mm
4 126mm
5 168mm
6 210mm
7 252mm
8 294mm
9 336mm
10 378mm
11 420mm
TECHNICAL REFERENCE
ADJUSTMENTS AND SETTINGS
1.12 Reel to Reel Manual Chapter Issue 1, Apr 15
Inner Transport
Vacuum Plate
Home Position
The home position is a datum for the software to use as a start point and is not
a critical position. The home vane should be fixed centrally to the two fixing
screws that secure it.