192866 Issue 4 - Reel to Reel Manual LoRes - 第29页
USER SETUP Chapter Issue 3, August 14 Reel to Reel Manual 2.5 cover the vacuum holes that are redundant behind the rear clamps. 34. If required, adjust the transport carriage belt s to suit the product reel, see Adjustme…
USER
SETUP
2.4 Reel to Reel Manual Chapter Issue 3, August 14
26. Loosen the securing screw that secures the outer rear transport clamp.
27. Place a sample of the product reel against the inner and outer front transport
clamps and adjust the rear transport clamps to approximately 0.5mm of the
rear edge of the product reel. Ensure the sample lays flat with no ripples or
creases.
28. Tighten the adjustment screws on the inner and outer rear transport clamps.
29. The outroad transport clamps are adjustable as to how much of the clamp
overlaps the product reel. If the clamps do not need adjustment, go to Step
33.
NOTE
The more of the clamp on the product reel, the better. Printing to the edges
of the product reel may require the clamps to be adjusted away from the print
medium.
30. On the inner rear transport clamp, use a screwdriver to loosen the two
securing screws and adjust the top plate of the clamp to suit the product.
31. Tighten the two securing screws.
32. Repeat Steps 30 and 31 for the other three transport clamps.
33. Slide the vacuum covers over the inner and outer transport vacuum plate to
Clamp Top Plate
Securing
Screws
USER
SETUP
Chapter Issue 3, August 14 Reel to Reel Manual 2.5
cover the vacuum holes that are redundant behind the rear clamps.
34. If required, adjust the transport carriage belts to suit the product reel, see
Adjustments and Settings - Transport Carriage Belts in the Technical Refer-
ence chapter of this manual.
35. Ensuring that the reel of product material is correctly aligned to the machine,
feed the product reel into the machine on the inroad conveyor ensuring that
the product reel is between the two product guides without any ripples or
creases.
36. Continue to feed the product reel past the rising table, ensure that the
Vacuum Covers
Transport Clamp Slides
Product Guides
View on Left Hand Side of the Machine
USER
SETUP
2.6 Reel to Reel Manual Chapter Issue 3, August 14
product reel is fed under the front and rear board clamps.
37. Feed the product reel through the four clamps on the outroad conveyor.
Front Board ClampRear Board Clamp
View on the Tooling Area of the Machine
Rear Clamps
Front Clamps
View on Right Hand Side of the Machine