CP6的IO代码 - 第275页

5. Make sure that the feed holes line up with the sprocket, pull the top-film out of the way, lower the tape leaf, and press the catch pins simultaneously to lock the tape leaf into place. Before the tape leaf is complet…

3. Slide the tape under the tape leaf and pull it to the tip of the feeder. Insert the top-

film into the slit in the tape leaf.

Setting the Top-film

4. Align the feed holes of the parts tape with the sprocket. Keep the pick-up position

in mind when aligning the tape to the sprocket.

Setting the Parts Tape

Pick-up point

CP6M8019

Parts tape

Slit

Top-film

CP6M8018

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-12 CP-6 Series Mechanical Reference

5. Make sure that the feed holes line up with the sprocket, pull the top-film out of the

way, lower the tape leaf, and press the catch pins simultaneously to lock the tape

leaf into place.

Before the tape leaf is completely closed, adjust the shutter position so that the cut-

out on the shutter engages with the pin on the arm.

If an arrow, " ▼ ", is marked on the tape leaf, slide the shutter until the arrow

meets the pin.

Note: If excessive force is applied to the tape leaf without aligning the cut-out with the pin, the

tape leaf will not be properly locked, or it will be deformed, resulting in a reduced pick-up

rate.

Closing the tape leaf

Tape leaf

Shutter

Catch pin

Cut-out

Align the arrow mark "▼"(or the cut-out)

and the pin on the shutter before locking.

Arrow mark

CP6M8020

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-13 CP-6 Series Mechanical Reference

6. Tie a knot in the end of the top-film, insert into the slit on the take-up reel cover

and pull until snug. On the take-up reel there are two arrows. When locking the

take-up reel, align the arrows and turn in the direction as shown below.

Setting the Top-film

7. After feeding the top-film through the rollers, rotate the take-up reel in the

direction of the arrow as shown. When the top-film is wound too tight, it is

necessary to turn the take-up reel in the opposite direction. Because there is

resistance in the take-up reel axis, it is necessary to use a little force when rotating.

Setting the Top-film

Roller

Top-film

CP6M8022

Slit

Take-up reel

Top-film

CP6M8021

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-14 CP-6 Series Mechanical Reference