CP6的IO代码 - 第280页

3. Slide the paper tape under the tape leaf and pull to the front of the feeder. Insert the adhesive tape into the shutter and pull to the back. Setting the Parts Reel 2 4. Set the adhesive tape under rollers 1 and 2 and…

2. Set the parts reel into the feeder holder. Set the components so that the parts feed

from the top of the reel as shown in the illustration. Make sure to use the center

pin in the holder.

Setting the Parts Reel 1

Note: Because the W32 paper feeders do not have rollers, make sure to use the center pin.

Parts reel

Parts tape

Holder

Groove

When loading components, insert

the pin into the center hole of the

parts reel, align the grooves on

the pin with the slots on the holder

and slide to the bottom-most point

of the holder.

CP6M8026

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-17 CP-6 Series Mechanical Reference

3. Slide the paper tape under the tape leaf and pull to the front of the feeder. Insert

the adhesive tape into the shutter and pull to the back.

Setting the Parts Reel 2

4. Set the adhesive tape under rollers 1 and 2 and cinch into the take-up reel. Tie a

knot in the end of the adhesive tape, insert into the slit on the take-up reel cover

and pull until snug. On the take-up reel there are two arrows. When locking the

take-up reel, align the arrows and turn in the direction as shown below.

Setting the Adhesive Tape

Take-up reel

Slit

Adhesive tape

Roller 1

Roller 2

CP6M8028

Tape leaf

Paper tape

Adhesive tape

Shutter

CP6M8027

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-18 CP-6 Series Mechanical Reference

5. Feed the adhesive tape through the rollers and wind the take-up reel as shown.

After feeding the adhesive tape through the rollers, rotate the take-up reel in the

direction of the arrow as shown. When the adhesive tape is wound too tight, it is

necessary to turn the take-up reel in the opposite direction. Because there is

resistance in the take-up reel axis, it is necessary to use a little force when rotating.

Setting the Adhesive Tape

6. Set the paper tape by aligning with the sprocket teeth. At this point, keep the pick-

up position in mind.

Setting the Parts Tape

Pickup point

CP6M8030

Take-up reel

Roller 2

Roller 1

Adhesive tape

CP6M8029

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-19 CP-6 Series Mechanical Reference