CP6的IO代码 - 第281页

5. Feed the adhesive tape through the rollers and wind the take-up reel as shown. After feeding the adhesive tape through the rollers, rotate the take-up reel in the direction of the arrow as shown. When the adhesive tap…

3. Slide the paper tape under the tape leaf and pull to the front of the feeder. Insert

the adhesive tape into the shutter and pull to the back.

Setting the Parts Reel 2

4. Set the adhesive tape under rollers 1 and 2 and cinch into the take-up reel. Tie a

knot in the end of the adhesive tape, insert into the slit on the take-up reel cover

and pull until snug. On the take-up reel there are two arrows. When locking the

take-up reel, align the arrows and turn in the direction as shown below.

Setting the Adhesive Tape

Take-up reel

Slit

Adhesive tape

Roller 1

Roller 2

CP6M8028

Tape leaf

Paper tape

Adhesive tape

Shutter

CP6M8027

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-18 CP-6 Series Mechanical Reference

5. Feed the adhesive tape through the rollers and wind the take-up reel as shown.

After feeding the adhesive tape through the rollers, rotate the take-up reel in the

direction of the arrow as shown. When the adhesive tape is wound too tight, it is

necessary to turn the take-up reel in the opposite direction. Because there is

resistance in the take-up reel axis, it is necessary to use a little force when rotating.

Setting the Adhesive Tape

6. Set the paper tape by aligning with the sprocket teeth. At this point, keep the pick-

up position in mind.

Setting the Parts Tape

Pickup point

CP6M8030

Take-up reel

Roller 2

Roller 1

Adhesive tape

CP6M8029

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-19 CP-6 Series Mechanical Reference

7. Return the tape leaf. Take-up the slack tape and confirm that the tape feed holes

are aligned with the sprocket teeth. Push in the clamp pins (one on the right side

and one on the left side) and slowly lower and lock the tape leaf. Be careful to not

cut the adhesive tape or the paper tape. When the tape leaf is not set properly, the

spring will raise the tape leaf.

Setting the Tape Leaf

8. Manually feed the part and check the pick-up position. To feed the part one pitch,

push the lever in the direction as shown.

Confirming Pick-up Position

Tape feed lever

CP6M8032

Tape leaf

Spring

Parts tape

Clamp pin

CP6M8031

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-20 CP-6 Series Mechanical Reference