CP6的IO代码 - 第305页

1.12 Feeder Jigs Use the following jigs to assist in feeder handling. Feeder Jigs • Using the Feeder Remover Jig This jig is used when setting a feeder or removing a feeder from the device table. Using the Feeder Remover…

1.11.2 Take-up Reel Drive Adjustment

This section covers only the W32 mm (paper) feeder.

If the take-up of the adhesive parts tape is not acting normally, adjust the take-up reel

drive force.

It is possible to use any one of three spring hook positions, allowing three different

settings for drive force.

Note : If the drive force is too weak, use the hook hole on the outside of the take-up lever.

Changing the Position of the Spring for the Adhesive Tape Take-up Reel

Spring

Take-up lever

Hook hole

CP6M8065

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-42 CP-6 Series Mechanical Reference

1.12 Feeder Jigs

Use the following jigs to assist in feeder handling.

Feeder Jigs

• Using the Feeder Remover Jig

This jig is used when setting a feeder or removing a feeder from the device table.

Using the Feeder Remover Jig

CP6M8067

Feeder remover

(Drawing # : WPJ 0780)

7-inch reel remover

(Drawing # : AWPJ 8040)

For 7-inch

For 13-inch

CP6M8066

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-43 CP-6 Series Mechanical Reference

• 7-inch Reel Remover Jig

The 7-inch reel remover jig is useful for removing 7-inch reels set in 13-inch

holders loaded on the device table as shown in the following drawing.

Using the 7-inch Reel Remover Jig

CP6M8068

Part 8 Chapter 1 WC Feeders

Edition 1.0 8-1-44 CP-6 Series Mechanical Reference