CP6的IO代码 - 第310页
4. Remove the spring used for the stopper. This is easy to remove when using a pencil/pen or other pointed instrument. Because the spring is small, be careful not to lose it. Caution : Take care not to misplace the sprin…
2. Feeder Maintenance
2.1 Disassembling the Feeder (WC type)
This section describes disassembly for the link assembly, sprocket and replacing the
feeding lever springs.
1. Remove the tape leaf. Unlock the tape leaf lock. When the E-ring and the pin are
removed, the tape leaf can be removed.
2. Remove the spring used for top-film take-up. Because this spring is weak, it is OK
to remove using your fingers.
Removing Top-film Take-up Spring
3. Remove the spring used for tape feed. Use needle nose pliers or other similar type
tool to remove the spring from the bracket. Because the spring is strong, do not
use your fingers to remove.
Replacing the Tape Feed Spring
Tape feed spring
CP6M8072
Top-film take-up spring
CP6M8071
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-1 CP-6 Series Mechanical Reference
4. Remove the spring used for the stopper. This is easy to remove when using a
pencil/pen or other pointed instrument. Because the spring is small, be careful
not to lose it.
Caution : Take care not to misplace the spring.
Removing the Sprocket Stopper Spring
5. Use a 8 mm box wrench to remove the nut and then remove the pin.
Caution : Do not loosen the eccentric pin tightening nut.
Removing the Pin
Wrench
Eccentric pin tightening nut
Nut
Pin
CP6M8074
Sprocket stopper spring
CP6M8073
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-2 CP-6 Series Mechanical Reference
6. Replace the sprocket. Be careful not to lose the 2 thin washers that are located on
each side of the sprocket.
Caution : Take care not to misplace the spacer.
When removing the sprocket, be sure not to bend the link.
Replacing the Sprocket
7. Remove the lever position pin and the joint pin. When the nuts are loosened, the
pin can be removed.
Removing the Link Assembly
Joint pin
Link Assembly
Nut
Lever position pin
CP6M8076
Spacer
Link
Sprocket
CP6M8075
Part 8 Chapter 2 Feeder Maintenance
Edition 1.0 8-2-3 CP-6 Series Mechanical Reference