00197195-02-UG SetupCenter 5.1_en - 第8页
Contents 8 U ser Guide SIPLACE Setup Center 5.1
Contents
User Guide SIPLACE Setup Center 5.1 7
8.12 Working with X-Feeders 177
8.12.1 Feeder Identification 177
8.12.2 Scan Request 177
8.12.2.1 Triggering a Scan Request 178
8.12.3 Setup Verification 179
8.12.4 Refill 181
8.12.5 Setting Up and Tearing Down X-Feeders 182
8.12.5.1 Setup Center Settings for X-Feeders and Their Effects 185
8.12.6 Tear Down After Foil Torn Error 185
8.13 Working with Machine IDs or Control Barcodes 186
8.14 Changeover Table Management 187
8.14.1 Status of a Changeover Table 188
8.14.2 Logging on a Changeover Table During Setup Verification (Steps with the Scanner) 189
8.14.3 Registering Changeover Tables at Another Setup (Moving Changeover Tables) 190
8.14.3.1 Moving a Changeover Table During Setup Verification (Steps with the Scanner) 192
8.14.4 Logging off the Changeover Table 193
8.14.5 Setup Change and Changeover Table Management 193
Contents
8 User Guide SIPLACE Setup Center 5.1
Introduction
Document Purpose / Target Group
User Guide SIPLACE Setup Center 5.1 9
1Introduction
1.1 Document Purpose / Target Group
This manual describes SIPLACE Setup Center. This documents provides new users with an overview
of SIPLACE Setup Center. We recommend that you read through this manual even if you are already
familiar with the main Setup Center features. Here you will find all the key information needed for con-
figurations and applications, in order to help make your work with the SIPLACE Setup Center easier.
Practical examples guide you "step by step" through the basic functions of SIPLACE Setup Center. At
the end of this document, you will be able to master the main tasks with SIPLACE Setup Center. You
can then build upon this knowledge in training sessions and learn about further functions.
The contents of this manual address the following user groups:
▪ Operator
The operator has completed appropriate training and is authorized to carry out tasks on the machine
and line, such as the configuration and refilling of components, setup verification and production
preparation in the pre-setup area.
▪ The line engineer
The line engineer has completed special training and is authorized to carry out tasks such as the
creation of setup configurations and definition of inspection parameters etc.
▪ The service engineer
Persons of this class have been trained to carry out servicing work, to set up machines and to change
the setup of machines.
1.2 Symbols / Notes
Different symbols and notes have been used to make it easier to read and understand this document.
CAUTION
Work must be carried out by qualified personnel
Only people with the appropriate training for the specific software part may carry out tasks on
the machine. All tasks must be carried out by trained and qualified personnel. All warning, cau-
tion and danger notes MUST be observed!
CAUTION
Contents of this manual are not part of any legal agreement
We would like to draw your attention to the fact that the contents of these software instructions
are not part of a previous or existing agreement, commitment or legal contract, neither is this
intended to modify one of the above. All obligations of ASM Assembly Systems GmbH & Co.
KG may be taken from the appropriate sales contract, which also contains a complete and valid
warranty agreement. These contractual statements are neither extended nor restricted by this
software guide.
Words in bold/italic print These refer to dialogs, dialog fields, menu items, and commands.
Step ... Includes all actions to do with a particular dialog. A dialog may be
composed of several actions ().