00900160-01_UM_ASM-ProcessLensDualLane_en - 第68页
4 Setting up and commissioning 4.4 Commissioning the machine 68 Instruction Guide ASM ProcessLens Dual-lane 06/2018 4.4.2 Removing the shipping braces ► Remove all the shipping braces (see next three figures). ► If the A…
4 Setting up and commissioning
4.4 Commissioning the machine
Instruction Guide ASM ProcessLens Dual-lane 06/2018 67
4.3.7 Removing the corrosion protection from the guide rails
The machines were given a corrosion protection treatment before they were delivered. Wipe off
from all the axes and bearings with a lint-free cloth.
CAUTION
Corrosion protection
► You should therefore remove the corrosion protection from all the axes and bearings
when you traverse the machine axes for the first time during commissioning.
► Grease all the axes and bearings with the grease described in the maintenance
instructions.
If the corrosion protection agent is mixed with the bearing grease on the axes this can greatly re-
duce the service life of the bearings and guide rails.
CAUTION
Cleaning the guide rails
Do not allow any alcohol to enter the guide carriages when you clean the guide rails and
scale rods. Alcohol will damage the bearing grease in the guide carriages.
4.4 Commissioning the machine
4.4.1 Commissioning the machine at the installation site
► Check all modules for correct seating.
► Store the machine until room temperature has been reached (minimum 4 hours). There is oth-
erwise a risk of condensation occurring.
ð Open all covers and doors.
ð Open the front lower cover plate.
ð Open the upper and lower rear cover.
ð Remove the desiccation bag.
► Wipe off the linear guide rails with a lint-free cloth before removing the shipping braces.
CAUTION
Do not use any solvents
► Please see section 4.3.7 "Removing the corrosion protection from the guide
rails" [}67].
4 Setting up and commissioning
4.4 Commissioning the machine
68 Instruction Guide ASM ProcessLens Dual-lane 06/2018
4.4.2 Removing the shipping braces
► Remove all the shipping braces (see next three figures).
► If the ASM ProcessLens Dual-lane machine needs to be transported, always fit the shipping
braces.
CAUTION
Always fit the shipping braces
Do not get rid of the shipping braces.
► Store the shipping braces for future use if ASM ProcessLens Dual-lane needs to be
moved to another location.
► If the ASM ProcessLens Dual-lane machine needs to be transported, always fit the
shipping braces.
Fig.40: Position of the shipping braces - Front side of the machine (part 1)
1 Shipping braces
4 Setting up and commissioning
4.4 Commissioning the machine
Instruction Guide ASM ProcessLens Dual-lane 06/2018 69
Fig.41: Position of the shipping braces - Front side of the machine (part 2)
1 Shipping braces