FCM_User Reference Manual.pdf.pdf - 第35页
4022 591 96082 User Re ference Manual 02.02 FCM Multiflex 3-19 Hu man Inte rfac e SCREE N 3-7 F CM Multiflex s tatus window when the BVM is present 3.8. 1 BVM Settin gs ■ T o be a uthor ized f or the f ollo w ing BV M se…
Human Interface
User Reference Manual 4022 591 96082
3-18 FCM Multiflex 02.02
3.8 Configuration BVM
This chapter deals with the human interface of the BVM.
This BVM human interface is a part of the FCM Multiflex human interface, which is -
in its turn - part of the FC controller software (see FIGURE 3-5).
FIGURE 3-5 Relations between BVM human interface and FCM Multiflex controller software
Just like in the other parts of the FCM Multiflex human interface, a distinction is
made between 3 authorization levels: Operator, Supervisor and Maintenance/Service
Engineer.
In normal operation the operator has no responsibilities concerning the BVM.
An operator has only to check via the status window (see SCREEN 3-7) if the BVM
has been enabled.
BVM Handler
Human Interface
TC Handler
Human Interface
Transpor t
Firmware
LAS Handler
Human Interface
LAS
Firmware
WVM Handler
Human Interface
WVM
Firmware
Bitbus
BVM
Firmware
FCM
Human Inter face
FCM Kernel
Mailbox
MIS
MIS DB
FC Control Software
Human InterfaceHuman InterfaceHuman Interface
4022 591 96082 User Reference Manual
02.02 FCM Multiflex 3-19
Human Interface
SCREEN 3-7 FCM Multiflex status window when the BVM is present
3.8.1 BVM Settings
■ To be authorized for the following BVM settings, switch to supervisor level via
the [User] pull-down menu (see below).
SCREEN 3-8
3.8.1.1 Enabling the BVM
■ Select [BVM] via the [Config] menu
SCREEN 3-9
Human Interface
User Reference Manual 4022 591 96082
3-20 FCM Multiflex 02.02
■ Select [Board Vision Module] via the [Options] menu
SCREEN 3-10
■ Select [Enable] and [Quit] in the BVM dialogue box
SCREEN 3-11
The BVM is now active.
!
WARNING: THIS DOESN’T NECESSARILY MEAN THAT THE DFA OR BMS OPTIONS HAVE
BEEN ENABLED!
NOTE: To indicate the presence of an active BVM, the BVM status indication in the
FCM Multiflex status window (see SCREEN 3-7) will now be [Ok].
3.8.1.2 Disabling the BVM
To disable the BVM, follow the same menu path as explained before (section
3.8.1.1) however selecting [Disable] instead.