AQ-2 spec book LR - 第18页

General Specifica tions 16 of 44 T ray stacker Supported tray type JEDEC- 95-1, I EC 60286-5 Number of thin tr ays 30 Number of thick tr ays 20 Number of diff erent componen ts 1 L oading mechanism Stacked tra ys (no pal…

100%1 / 45
General Specifications
15 of 44
User benefits
• Standard top plate support for most used stick components
• Easy replaceable top plates
• Custom top plate support for long term use in operations of non-supported
component ranges or component mixes
• Generic top plate support for support for quick use in operations of non-supported
component ranges or component mix
• Customized top plates available at request
• Occupies 6 feeder slots
Supported component range:
• SO14/16, SOL-IC 16/20/28, SOM-IC 14/16/20
• SOLJ 26, SOLJ32, SOXJ 32, SOXJ 44
• PLCC 18, PLCC 20, PLCC 28/32, PLCC 44,
• PLCC 52, PLCC 68, PLCC 84, PLCC 100
• Generic (max. tube width: 70mm, max. tube height = 6.3mm,
max. tube length = 430mm).
User benefits
• Increase throughput by automatically delivering trays non-stop
• Low cost of ownership
• Efficient operation due to low interaction
• No pallet setup time or pallet teaching
3.1.3 Stick feeding
3.1.4 Tray stackers
Figure 11
Figure 12
General Specifications
16 of 44
Tray stacker
Supported tray type JEDEC-95-1, IEC 60286-5
Number of thin trays 30
Number of thick trays 20
Number of different components 1
Loading mechanism Stacked trays (no pallets)
Loading time ~ 10 seconds for 20 or 30 trays
Unloading time < 5 seconds for up to 30 trays
Tray exchange time ~ 4 seconds in standard mode
Mode settings (Speed) Standard and slow
Feeder slots 11
User benefits
• Fast and accurate presentation of pre-printed labels
• More economical than manual applied labels
• The exchangeable label module allows the feeder to present a variety of label types
Label feeder
Label types Pre-Printed labels
Label presenter Detachable, specific to label
liner width and label length
Advance rate 53mm/sec (2.1 inch/sec)
Pick point repeatability ± 0.25mm (± 0.010 inch)
Feeder slots 5
Table 9
3.1.5 Label feeders
Figure 13
Table 10
General Specifications
17 of 44
User benefits
• Based on ITF2 8mm design. Occupies only one feeder slot.
User benefits
• Support of 2”x2” and 4”x4” waffle packs
• Easy load and unload of waffle packs
• Operation efficient due to low operator interaction
• Automatic waffle pack loading and eject
• Waffles loaded as a stack rather than on pallets
3.1.6 Advanced
packaging
feeders
3.1.6.1 Surftape
feeding
3.1.6.2 Waffle pack
feeding
Surftape feeder
Surftape width 8mm (Standard or Surftape XF®
Maximum die size 2.5mm (Longest edge length)
Minimum die size 0.3mm (Shortest edge length)
Die presentation Chip on board (Bumps up)
Figure 14
Figure 15
Table 11