AQ-2 spec book LR - 第20页
Direct die feeder Die size 0 .5mm to 10mm Minimum die thickness 0 .05mm minimum thickness Die delivery rate Flip chip : 3000 die per hour Wire-bond : 3600 die per hour Burst mode : 6 die per second Machine vision Pattern…
General Specifications
17 of 44
User benefits
• Based on ITF2 8mm design. Occupies only one feeder slot.
User benefits
• Support of 2”x2” and 4”x4” waffle packs
• Easy load and unload of waffle packs
• Operation efficient due to low operator interaction
• Automatic waffle pack loading and eject
• Waffles loaded as a stack rather than on pallets
3.1.6 Advanced
packaging
feeders
3.1.6.1 Surftape
feeding
3.1.6.2 Waffle pack
feeding
Surftape feeder
Surftape width 8mm (Standard or Surftape XF®
Maximum die size 2.5mm (Longest edge length)
Minimum die size 0.3mm (Shortest edge length)
Die presentation Chip on board (Bumps up)
Figure 14
Figure 15
Table 11
Direct die feeder
Die size 0.5mm to 10mm
Minimum die thickness 0.05mm minimum thickness
Die delivery rate Flip chip : 3000 die per hour
Wire-bond : 3600 die per hour
Burst mode : 6 die per second
Machine vision Pattern matching, corner
detection, inkt dot and BGA
bump recognition.
General Specifications
18 of 44
Waffle pack feeding 2” x 2” 4” x 4”
Maximum number of waffle packs 50 (45 20
recommended)
Minimum die size (shortest edge length) 1mm 1.27mm
Maximum die size (longest edge length) Limited by Limited by
system system
capabilities capabilities
Slot occupation 6 10
Waffle index time < 3 sec < 4 sec
Approximate manual loading / unloading time ~ 10 sec ~ 10 sec
(per maximum number of waffle packs)
3.1.6.3 Direct die
feeding
User benefits
• Bare die product directly picked from wafer
• Eliminates all taping costs
• Uses threshold and pattern matching to select only qualified die for picking
• Supports flip-chip or wire bond
• Two versions: Shuttle (small and thin bare die products) and Conveyor (thicker and
larger bare die products)
Table 12
Table 13
General Specifications
19 of 44
3.1.7 Odd form
feeding
3.1.7.1 GPAX
feeding
3.1.7.2 Radial tape
feeding
User benefits
• Support of most oddform type components
• Low friction pockets for easy pick
• Operating efficiency through low operator interaction due to high on-board
component capacity
GPAX feeder
Tape specifications EIA-SI/704-2
Tape types Thru-pax, semi-pocket, flatpax
44mm – 200mm
Component locations Single or matrix tape layout.
XY Accuracy on leads: ± 0.05
Table 14
Figure 16
Figure 17
User benefits
• Easy to use and rugged construction
• Support for 12.7mm and 15mm radial tapes
• Support for reels and AmmoPacks
• Slanted cut action possible for enhanced component insertion