YSM10安装调整(eng) - 第21页
For Ser v ice E n gineer Service Information SI1610004E -000= YSM10_Proced ures for the adjustmen ts required after installing a machine 21/107 6. Perform the me asurement again after correcting the data. …
For Service Engineer
Service Information
SI1610004E-000= YSM10_Procedures for the adjustments required after installing a machine
20/107
3. Check the reference coordinate of the mark.
(
0.5mm)
ﾓｓｴ､
Figure 19
ｭ｡ｲｫ
“No.1 ｧｬ｡ｳｳ_0.5_Circle” “MCH_SETUP”
“Mark Adj” .
4. .
Figure 20
5. ＠
:
<> <>
Figure 21
Item
Specification
0.0015 deg
Table 14
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
For Service Engineer
Service Information
SI1610004E-000= YSM10_Procedures for the adjustments required after installing a machine
21/107
6. Perform the measurement again after correcting the data.
7. Make sure that the variation of the perpendicularity falls within the specification.
Item
Specivied value
0.0015 deg
Table 15
8. “Table A-Sub Camera”.
Figure 22
9.
[Trace] .
10. [Teach] and check the mark coordinate with the sub camera.
Ｒﾔ
Figure 23
11.
[Execute] .
12. Check the variation of the perpendicularity.
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
For Service Engineer
Service Information
SI1610004E-000= YSM10_Procedures for the adjustments required after installing a machine
22/107
4.7 “BaseMACS”
“BaseMACS” ,
When is the “BaseMACS”adjustment required? BaseMACS
ﾓｌｩｧｨｴｮ･ｳｳ
ﾓｂ｡ｳ･ｍａｃｓﾔ
ｂ｡ｳ･ｍａ
Adjustment procedures
1.
[021 BaseMACS] CalibSm “BaseMACS” .
Figure 24
2. “Adjust All” “Adjust Item”
“BaseMACS”
“Ajust All”.
3. [Execute] .
[Execute] , BaseMACS
4.
BaseMACS
5. [Execute] .
[Execute] 0.01mm .
:
,
, ｭ｡ｲｫ
“ 301” ( ) . “Setting”
“Machine Data”
“Precision”
“Base MACS” VmSpec .
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/