F4000N_revD.pdf - 第48页
F4000N Series Operating Manual Section 5: Point T ype & Function Reference Part # 562187N - 1 Rev . D Sep 201 2 47 © 20 12 Fisnar Inc. 1.12.4 Brush Area: Rect. B and Brush Area Rect. Ba nd caus es the tip to „paint‟ …
F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
46
© 2012 Fisnar Inc.
1.12.3 Brush Area: Rectangle 1
Brush Area Rectangle 1 causes the tip to „paint‟ the defined area by following a square
spiral path from the outside of the rectangle to the center.
After registering the Brush Area Rectangle 1 command, teach a Line Starting point at the
top left corner of the area to be brushed and a Line End point at the bottom right corner of
that area (the tip will not dispense a straight line between these two points):
If, for example, a brush width of 5 mm was used, the tip will take the following path when
the program is run:
Line Start
Line End
Paint
Area
5 mm
5mm
F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
47
© 2012 Fisnar Inc.
1.12.4 Brush Area: Rect. Band
Brush Area Rect. Band causes the tip to „paint‟ a defined rectangular band area by
following a square spiral path from the outside of the rectangle to the center.
After registering the Brush Area Rect. Band command, teach a Line Start point at the top
left corner of the area to be brushed and a Line End point at the bottom right corner of that
area (the tip will not dispense a straight line between these two points):
If, for example, a brush width of 5 mm and band of 10mm was used, the tip will take the
following path when the program is run:
Band 10mm
Width 5mm
Line Start
Line End
F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
48
© 2012 Fisnar Inc.
1.12.5 Brush Area: Circle Band
Brush Area Circle Band causes the tip to „paint‟ a defined circular band area by following a
spiral path from the outside limit of the circle to the center of the circle.
After registering the Brush Area Circle Band command, jog the tip to a point on the outside
limit of the circle to be brushed and register that location as a Line Start point. Then jog
the tip directly across to the center of the circle and register that location as a Line End
point (the tip will not dispense a straight line between these two points):
If, for example, a brush width of 5 mm and Band of 15mm was used, the tip will take the
following path when the program is run:
Line Start
Line End
Paint Area