Service Manual HS60 - 第137页
Se rv ice M a nu al HS- 6 0 5 P ne um at ic Cu tte r an d Em pt y-T ap e D uc t 03 /2 003 U S I ssue 5.5 Di ag ram s o f Pn eu mat ic S yst em a nd Fu ncti on al Se qu en ce 135 5.5 Diagram s of Pneum atic Syste m and Fu…
5 Pneumatic Cutter and Empty-Tape Duct Service Manual HS-60
5.4 Overview of Mechanical Layout 03/2003 US Issue
134
Key to Fig. 5.4.2
:
1. Cover plate
2. Cover plate holder, left
3. Cover plate holder, right
4. Screws to fasten the cover plate holder:
2 hexagon socket head screws M4 x 8 DIN 84 or 2 countersunk screws R M4 x 6 DIN 965 each
5. Screws to fasten the cover plate (incl. tape deflector) -> do not loosen!
6. Tape deflector (with moveable blade underneath)
7. Tape deflector holder, left
8. Tape deflector holder, right
9. Screws to fasten the tape deflector holders: 2 socket hex head cap screws M4 x 35 each on
the left and right
10. Screws to fasten the tape deflector: 1 countersunk screw each -> do not loosen!
11. Holddowns (at left and right) with spacers inserted underneath them
12. Deflector plate
13. Screws to fasten the deflector plate: 4 socket hex head cap screws M4 x 8
14. Screws to fasten the cutter on the machine frame
4 socket hex head cap screws M 6 x 25 *)
15. Any disks or plates installed underneath
16. Stationary blade
17. Rubber-metal vibration damper
18. Any disks and spring washers installed underneath
5
*) Loosen these screws only when removing/installing the cutter (see Section 5.6.1
). 5
Service Manual HS-60 5 Pneumatic Cutter and Empty-Tape Duct
03/2003 US Issue 5.5 Diagrams of Pneumatic System and Functional Sequence
135
5.5 Diagrams of Pneumatic System and Functional
Sequence
Fig. 5.5.1 Diagram of Pneumatic System: Cutter per Conveyor Side
5 Pneumatic Cutter and Empty-Tape Duct Service Manual HS-60
5.6 Changing of parts 03/2003 US Issue
136
5.6 Changing of parts
DANGER
Strictly adhere to the instructions in the DANGER text in Section 5.1! 5
WARNING
Wear appropriate thick protective gloves whenever working near the blades / the tape deflector.
High risk of injury exists from stationary blade and movable blade and the tape deflector of the
cutter, even when the machine has been turned off.
Never reach into the pneumatic cutter from below or into the empty-tape duct from above, not
even to resolve a problem (e.g., when tape is jammed). 5
5.6.1 Exchanging the Pneumatic Cutter
WARNING
Wear appropriate thick protective gloves.
When removing the cutter, hold it only on the left and right, on the outside.
Never support the cutter on your body, e.g., on your knees or thighs.
Do not place your feet under the cutter.
You could injury yourself severely or at least damage your clothing.
Make certain that no one can injury themselves on the cutter after it has been dismantled. 5