Service Manual HS60 - 第23页

Se rv ice M a nu al HS-6 0 2 Ope rati on al saf et y 03/ 200 3 U S Iss ue 2.1 S afe ty in str ucti ons 21 2.1. 7 Safety ins t ruct ions on perm anent mag nets S trong perma nent magnets are used for t he Y -axis li nea r…

2 Operational safety Service Manual HS-60

2.1 Safety instructions 03/2003 US Issue

WARNING 2

The system is electrically driven. When electrical devices are in use, certain parts carry dangerous

voltage levels.

Æ Switch off at the main switch and disconnect the placement system from the power supply be-

fore carrying out any work on live components.

Æ Lock the systems as described in Section 2.8, page 62.

There is a risk of death, severe injury and/or considerable damage to equipment if these instruc-

tions are not followed.

2.1.5.3 Safety of plant and equipment

Æ Never make changes, however minor, unless you are totally aware of the effect they will have

on the overall functioning of the system.

Æ The stations must always be set up, retooled and maintained by appropriately trained person-

nel.

Æ Only use SIEMENSDEMATIC original spare parts and authorized accessories. The use of

other parts will affect safety and will invalidate the liability for any consequential damage.

Æ Do not make modifications to the safety equipment. In particular, NEVER bypass circuit-break-

ers or remove safety devices.

2.1.6 Safety instructions for laser units

Permission to operate components that are classified as lasers is withdrawn if

– mechanical damage to the unit is observed, or

– any work is done on the mechanical or electrical parts of the unit.

Even damaged or missing screw locking paint on laser components (e.g. cover plates, fas-

teners, adjusting potentiometer) counts as work.

– Only SIEMENSDEMATIC AG service engineers, or the machine owner's service engineers

who have been trained by SIEMENSDEMATIC are allowed to replace laser components.

– Repairs to laser units are carried out at the SIEMENS DEMATIC factory exclusively.

Service Manual HS-60 2 Operational safety

03/2003 US Issue 2.1 Safety instructions

2.1.7 Safety instructions on permanent magnets

Strong permanent magnets are used for the Y-axis linear motor.

DANGER OF DEATH

STRONG PERMANENT MAGNETIC FIELDS INSIDE THE MACHINE 2

The life of persons with passive or active implants such as pacemakers, defibrillators, insulin

pumps etc. is put at risk inside the machine if protective covers are opened.

CAUTION STRONG MAGNETIC FIELDS 2

There is a risk that the strong magnetic fields could corrupt data on data media or credit cards

and check cards.

2.1.8 Important notes on environmentally-friendly disposal of materials

and components

SIPLACE systems are manufactured using only materials and parts that can be easily separated

and disposed of in an environmentally-friendly way. Hazardous materials are not necessary for the

installation, dismantling or operation of the system.

NOTE 2

The owner of the system has sole responsibility for the proper environmentally-friendly disposal

of machines, working materials, consumables and wear parts.

Æ Please observe your national statutory provisions for waste disposal and environmental pro-

tection.

2 Operational safety Service Manual HS-60

2.2 Warning labels 03/2003 US Issue

2.2 Warning labels

2.2.1 Warning labels W201, W203, and W204 on the machine

The warning labels are made from soft PVC film, and are abrasion-proof, light-fast and resistant

to water and weathering.

Their design meets the requirements of ISO 3864-2 and ANSI Z535.4.

Fig. 2.2 - 1 Warning labels W201, W202, W203, W204, and W206 on the machine

WARNING 2

– Do not use abrasive cleaners or solvents for cleaning warning labels.

– Replace any damaged or illegible warning or notice labels.