Service Manual HS60 - 第280页
7 DL M2 Co llec t &P lace Head H S-6 0 S erv ic e Manu al 7. 8 R ep laci ng th e t ur n in g st at i on ( 0 0341 78 0-0 3) 03/2 00 3 US I ss ue 278 F ig. 7. 8 - 1 P lu g-i n co nn ec tio ns o f t he tu rni ng s tati …
HS-60 Service Manual 7 DLM2 Collect&Place Head
03/2003 US Issue 7.8 Replacing the turning station (00341780-03)
277
7.8 Replacing the turning station (00341780-03)
7.8.1 Tools and equipment
– Set of DIN 911 Allen keys
– SITEST program
7.8.2 Parts
Turning station / DLM2, item no. 00341780-03 7
7.8.3 Dismantling the turning station
Æ Switch the placement system off and secure it to prevent switching on again as described in
Section 7.4
, page 261.
Æ Remove the plugs from sockets X12 and X18 on the head board.
7 DLM2 Collect&Place Head HS-60 Service Manual
7.8 Replacing the turning station (00341780-03) 03/2003 US Issue
278
Fig. 7.8 - 1 Plug-in connections of the turning station on the head board
Æ Push the collect&place head until it reaches the stopper on the deflection roller of the X-axis
toothed belt.
Æ Undo the M3x25 hexagon socket-head screw (see item 2 in Fig. 7.8 - 2) on the rear panel of
the back part.
Æ Carefully pull the turning station (item 1 in Fig. 7.8 - 2) back and remove.
HS-60 Service Manual 7 DLM2 Collect&Place Head
03/2003 US Issue 7.8 Replacing the turning station (00341780-03)
279
Fig. 7.8 - 2 Turning station / DLM2
Key to Fig. 7.8 - 2
(1) Turning station / DLM2
(2) M3x25 hexagon socket-head screw
(3) Back part of the collect&place head
7.8.4 Fitting the turning station
Æ Make sure that the contact surfaces of the turning station and rear panel are clean.
Æ Insert the M3 x 25 hexagon socket-head screw (item 2 in Fig. 7.8 - 1) into the hole in the cen-
tering station.
Æ Run the cable between the vacuum hose and the vacuum generation socket.
Æ Place the holes in the turning station on the parallel pins.
Æ Carefully push the turning station towards the back part until it reaches the stop.
Æ Fix the turning station with the hexagon socket-head screw.