Maintenance Manual - 第177页
AV131 MAINTENANCE MANUAL 8. MA IN TENAN CE GU IDE D79MEC- 83-AA0- A0 8-4
AV131
MAINTENANCE MANUAL
8. MAINTENANCE GUIDE
D79MEC-83-AA0-A0
8-3
Related Works in Sequence
This chapter presents the relations among the maintenance works as shown in the following:
Work which should have been
completed in advance
Work explained in the section
Work which should be carried out
next
When there is no works to be done before or after the work explained in the section.
Safety Precautions
Before conducting inspection, read ‘Mtn. / SAFETY PRECAUTIONS’ thoroughly.
AV131
MAINTENANCE MANUAL
8. MAINTENANCE GUIDE
D79MEC-83-AA0-A0
8-4
AV131
MAINTENANCE MANUAL
8.1 Anvil Unit
D79MEC-W4-400-A0
8.1-1
8.1. Anvil Unit
D79MEC-W4-400-A0
8.1.1 Anvil Unit Consumable Parts Replacement
Unit No. N610052020AA
8.1.1 Anvil Unit Consumable Parts
Replacement
Anvil Unit Consumable Parts Replacement
7.
1. Turn the power OFF.
2. Disconnect the tube and connector from the anvil.
3. Remove the anvil unit from the machine.
4. Loosen the clinch base bolts (2 pcs.) and remove the
clinch base.
5. Loosen the flush bolts (2 pcs.) and remove the cover.
6. Loosen the clinch base bolts (2 pcs.) and the flush bolts (2
pcs.) from the other clinch base and remove.
7. Attach the cover to the new clinch base and tighten the
flush bolts (2 pcs.).
8. Loosen the cutter & clincher bolts (2 pcs.) and remove the
cutter & clincher of one side.
9. Attach a new cutter & clincher.
10. Tighten the cutter & clincher bolts (2 pcs.).
11. Attach a new clinch base and tighten the bolts (2 pcs.). Fit
the clinch base to the block and loosen the bolts.
12. Replace the cutter & clincher and clinch base of the other
side similarly.
13. Check the clearance between the clinch base and the cutter & clincher.
=SPECIFICATION=
Clearance: 0.01 - 0.03 mm
14. Tighten the cutter & clincher bolts (2 pcs.).
0.01 -
0.03 mm
Clinch base
Clinch base
bolt
Pin
Lever
Cutter & clincher
Cutter &
clincher bolt
Cover
Flush
bolt