00197279-03_SM_Glue-Feeder_EN - 第13页
Replacing Spare Parts 3.4.1 Removing the Sliding Guide Rear Sliding Guide Service Manual SIPLACE Glue Feeder 13 3.4 3 . 4 R e a r S lid in g G u id e Rear Sliding Guide Required spare parts Sliding guide/rear L200 , item…
Replacing Spare Parts
Sliding film 3.3.1 Removing the Sliding Foil
12 Service Manual SIPLACE Glue Feeder
3.3
3.3 Sliding film
Sliding film
Required spare parts
Sliding foil, X-feeder JUM-S-06LY, item no. 03019604-xx
Required tools
▪ Sliding foil remover
3.3.1
3.3.1 Removing the Sliding Foil
Removing the Sliding Foil
3.3.2
3.3.2 Fitting the Sliding Foil
Fitting the Sliding Foil
► Place the glue feeder carefully down on its side, onto
a stable, level and clean surface.
► Place the sliding foil remover into the sliding guide, as
shown in the diagram.
► Lever the sliding foil out of the engaged position.
► Pull the sliding foil out of the sliding guide, towards
the front.
► Press the sliding foil slightly together.
► Push the sliding foil into the sliding guide, from the
front, as far as the end stop.
► Turn the sliding foil, until the slit can be fully seen and
the sliding foil engages audibly.
Replacing Spare Parts
3.4.1 Removing the Sliding Guide Rear Sliding Guide
Service Manual SIPLACE Glue Feeder 13
3.4
3.4 Rear Sliding Guide
Rear Sliding Guide
Required spare parts
Sliding guide/rear L200, item no. 03003994-xx
Required tools
▪ Phillips screwdriver
3.4.1
3.4.1 Removing the Sliding Guide
Removing the Sliding Guide
3.4.2
3.4.2 Fitting the Sliding Guide
Fitting the Sliding Guide
► Turn the glue feeder so that the underside is at the
top.
► Remove the 4 marked screws on the sliding guide.
Use a Phillips screwdriver for this.
► Lift the sliding guide upwards and off.
► Turn the glue feeder so that the underside is at the
top.
► Fit the sliding guide onto the underside of the glue
feeder.
Make sure that the arrangement of holes in the sliding
guide corresponds to that in the glue feeder.
► Push the sliding guide, as shown, forward towards
the front sliding guide, as far as the stop.
Replacing Spare Parts
Rear Sliding Guide 3.4.2 Fitting the Sliding Guide
14 Service Manual SIPLACE Glue Feeder
► Now lower the two snap tabs of the sliding guide into
the openings provided on the underside of the glue
feeder.
► Use the 4 screws to fasten the sliding guide to the
glue feeder. Use a Phillips screwdriver for this.