00197279-03_SM_Glue-Feeder_EN - 第77页
Replacing Spare Parts 3.19.1 Removing the Regulator Holder Regulator Holder Assembly Service Manual SIPLACE Glue Feeder 77 3.19 3 . 1 9 R e g u la t o r H o ld e r A s s e m b ly Regulator Holder Assembly Required spare …
Replacing Spare Parts
Solenoid valve 3.18.2 Fitting the Solenoid Valve
76 Service Manual SIPLACE Glue Feeder
See also
3.8.2 Fitting the Right Side Cover [ ➙ 21]
► Insert the one hose into the top connection on the T-
connector.
► Insert the other hose into the right-hand connection
on the T-connector.
► Use the two marked screws to fasten the solenoid
valve to the frame. Use a size 2.5 Allen key for this.
► Fasten the right side cover (see .
Replacing Spare Parts
3.19.1 Removing the Regulator Holder Regulator Holder Assembly
Service Manual SIPLACE Glue Feeder 77
3.19
3.19 Regulator Holder Assembly
Regulator Holder Assembly
Required spare parts
Regulator holder assembly, item no. 03097710-xx
Required tools
▪ Allen key size 2
3.19.1
3.19.1 Removing the Regulator Holder
Removing the Regulator Holder
NOTICE
Assembly instructions
The regulator holder is always replaced as a complete unit.
This regulator holder is preset at the factory and is supplied ready for use.
► Remove the right side cover (see "3.8.1 Removing
the Right Side Cover" [ ➙ 21])
► Mark the hose indicated in the diagram, with adhe
-
sive tape.
► Open the lock and pull the marked hose out of the
connection on the right-hand side. (1)
► Open the lock and pull the hose out of the connection
on the left side. (2)
Replacing Spare Parts
Regulator Holder Assembly 3.19.2 Fitting the Regulator Holder
78 Service Manual SIPLACE Glue Feeder
3.19.2
3.19.2 Fitting the Regulator Holder
Fitting the Regulator Holder
See also
3.8.2 Fitting the Right Side Cover [ ➙ 21]
► Carefully place the glue feeder down on its left side.
► Remove the two marked screws. Use a size 2 Allen
key for this.
► Remove the regulator holder.
► Carefully place the glue feeder down on its left side.
► Coat the tips of the two screws with LOCTITE 243.
► Use the two marked screws to fasten the regulator
holder. Take a size 2 Allen key for this.
► Insert the UNMARKED hose as far as possible into
the connection on the left side. (1)
► Insert the marked hose as far as possible into the
connection on the right-hand side. (2)
► Fasten the right side cover (see .