00197279-03_SM_Glue-Feeder_EN - 第89页

Replacing Spare Parts 3.24.1 Removing the Handle Assembly Handle assembly Service Manual SIPLACE Glue Feeder 89 3.24 3 . 2 4 H a n d le a s s e m b ly Handle assembly Required spare parts H andle with control panel V1 Gl…

Replacing Spare Parts

EDIF Secondary Assembly 3.23.2 Fitting the EDIF

88 Service Manual SIPLACE Glue Feeder

3.23.2

3.23.2 Fitting the EDIF

Fitting the EDIF

► Check the compression springs for damage and re

place if necessary.

► Insert the EDIF and fasten into place with the two col

lar screws (1). Use a slotted screwdriver for this.

Make sure that the two compression springs point to

the front and are not distorted.

► Check whether the EDIF springs back to the front if

slight pressure is applied to it.

► If the EDIF does not spring back, loosen the collar

screws (1) and check or correct the position of the

two compression springs (see above).

► Place the connector on the main board, ensuring the

alignment pins engage in the holes.

► Carefully screw the connector to the board. (2) Use a

size 2 Allen key for this.

► Fasten the left side cover (see "3.7.2 Fitting the Left

Side Cover" [ ➙ 20].

Replacing Spare Parts

3.24.1 Removing the Handle Assembly Handle assembly

Service Manual SIPLACE Glue Feeder 89

3.24

3.24 Handle assembly

Handle assembly

Required spare parts

Handle with control panel V1 GlueFeeder, part no.: 03133349-01

(prefitted with flat ribbon cable)

Required tools

▪ Allen key, size 2.5

▪ TORX screwdriver size T8

▪ Open-ended wrench, size 24

3.24.1

3.24.1 Removing the Handle Assembly

Removing the Handle Assembly

► Remove the left side cover (see "3.7.1 Removing the

Left Side Cover" [ ➙ 20].

► Carefully place the glue feeder down on its right side.

► Open the bar on the flat ribbon connection on the

control board. (1)

► Unplug the flat ribbon cable form the connection. (2)

► Remove the two marked Torx screws.

Replacing Spare Parts

Handle assembly 3.24.1 Removing the Handle Assembly

90 Service Manual SIPLACE Glue Feeder

► Remove the marked Allen screw. Use a size 2.5 Allen

key for this.

► Remove the right side cover (see "3.8.1 Removing

the Right Side Cover" [ ➙ 21])

► Pull the cover on the pressure control valve up and

off. (1)

► Remove the nut fastening the pressure control valve.

Use a size 24 fork wrench for this. (2)

► Carefully pull the pressure control valve vertically

downwards and out of the glue feeder frame.