Machine Control.pdf - 第50页

MACHINE CONTROL SIGNALS BREAKOUT CONNECTOR 7.50 Technical Reference Manu al Chapter Issue 3 Jan 08 SIGNALS BREAKOUT CONNECTOR Mounted on the rear frame o f the machine, the signals breakout connectors are extensions of s…

100%1 / 50
MACHINE CONTROL
CAN BUS
7.48 Technical Reference Manual Chapter Issue 3 Jan 08
N4SK13
N4SK14
N4SK15
Pin No. Signal Pin No. Signal
1 +12V 3 0V
2 Spare Input
1
3 Way Trident Connector
Pin No. Signal Pin No. Signal
1 +12V 3 0V
2 Spare Input
1
3 Way Trident Connector
Pin No. Signal Pin No. Signal
1 Cleaner Camera Clamp 2 0V
2 Way Trident Connector
1
MACHINE CONTROL
CAN BUS
Chapter Issue 3 Jan 08 Technical Reference Manual 7.49
Servo/Stepper
Nodes
These nodes can be either servo or stepper motors with built in sensors,
controller, drive electronics and CAN encoder/decoder. The motor is connected
to the CAN Bus allowing direct communications with the NextMove ES card in
the M36 Machine Control Enclosure.
The following motors are fitted to all machines:
• Servo Node 6 - Rising Table Motor
• Servo Node 7 - Print Carriage Motor
The following motors may be fitted dependant on machine options and variants:
• Servo Node 8 - Camera X Motor (rotary drive machines only)
• Servo Node 9 - Camera Y Motor (rotary drive machines only)
• Stepper Node 10 - Paste Dispenser Motor (optional)
• Stepper Node 15 - Pass Through Lane Rail Width Motor (Dual Lane only)
NOTE
For further information on the servo/stepper motors above, refer to the relevant
chapter of this manual.
Servo/Stepper
Motor
(Brushless)
Drive
Electronics
Processor
CAN
Encoder/
Decoder
CAN Bus In
CAN Bus Out
DC Supply In
CAN Motor Block Diagram
MACHINE CONTROL
SIGNALS BREAKOUT CONNECTOR
7.50 Technical Reference Manual Chapter Issue 3 Jan 08
SIGNALS BREAKOUT CONNECTOR
Mounted on the rear frame of the machine, the signals breakout connectors are
extensions of some of the I/Os from the NextMove Interface card. The Spare
Output and Inputs are available for machine options.
Pin 1
Pin 2
Pin 3
+12V
DIG IN 19
0V
Rail Clash Sensor
(Dual Lane machine only)
Wire 001
Wire 021
Wire 180
12VWire 021
Pin 1
Pin 2
Pin 3
DIG IN 5
0V
Moving Rail Home
Wire 166
Wire 001
Pin 1
Pin 2
Pin 3
+12V
DIG IN 0
0V
Spare Input
Wire 161
Wire 021
Wire 001
Pin 1
Pin 2
Pin 3
+12V
DIG IN 2
0V
Camera Y Home (linear motors)
Wire 021
Wire 163
Wire 001
8SK24 8SK25 8SK26 8SK27
8SK28
Pin 1
Pin 2
DIG OUT 4
0V Return
HTC Enable/Spare Output
Wire 185
Wire 050
Pin 1
Pin 1