00193903-02 - 第22页
8 External power supply for SIPLACE HF-Series / D3 component trolley SIPLACE HF-series / D3 06/2006 Edition 22 6.0.2 Changing the fuse 6 Fig. 7 Power switch with fuse s 7 : Switch the power switch (3) to OFF and ma ke su…
SIPLACE HF-series / D3 8 External power supply for SIPLACE HF-Series / D3 component trolley
06/2006 Edition
21
5.2 Preventive maintenance
5.2.1 Compressed air filter
The microfilter (see figure below) should be replaced if the flow rate drops sharply. 5
Release the coupling and remove it from the compressed air connector (Fig. 3). Then unscrew the
condensate tank from the pressure-reducing valve (1), and press down on the separating cap (3)
to remove the microfilter (2). 5
Reverse the above sequence to insert the new microfilter. 5
5
Fig. 6 Compressed air filter unit
a Pressure-reducing valve
s Microfilter
d Separating cap
f Condensate tank
g Manual drain valve
6.0.1 Condensate
The transparent condensate tank (see figure above) must be emptied before the condensate level
reaches the separating cap (3). To do this, press the manual drain valve (5) up. 6
8 External power supply for SIPLACE HF-Series / D3 component trolley SIPLACE HF-series / D3
06/2006 Edition
22
6.0.2 Changing the fuse
6
Fig. 7 Power switch with fuses
7
: Switch the power switch (3) to OFF and make sure that the mains plug is not plugged in the
unit.
: Push up the snap-fit closure (9) to release and pull out the black plastic insert (7) with the fuses.
: Remove and check the two fuses (5) and replace them if necessary.
: Only use type 5x20 mm / medium time-lag 6.3 Amp fuses (e.g. 03011614-01).
: Push the black plastic insert (7) with the fuses back into the unit until the snap-fit closure lat-
ches into place.
7
SIPLACE HF-series / D3 8 External power supply for SIPLACE HF-Series / D3 component trolley
06/2006 Edition
23
7.1 Technical data
7.1.1 Compressed air
Input pressure: max. 10 bar (= 1000 kPa) 7
Output pressure: 2.5 bar (= 250 kPa) 7
7.1.2 Mains voltage
7.1.3 Weights / dimensions
Weight: 4.3 kg 7
Dimensions: W x D x H = 180 x 360 x 210 mm 7
7
7
Voltage
88 - 264 VAC
Frequency
47...63 Hz
Nominal current
5A / 115 VAC 2,5A / 230 VAC
Fuse
6,3A MT (medium time-lag)