SA_HF_intern_0194307-02_eng - 第25页

SIPL ACE HF-Ser ies Replacing the Gantry [030 06781-xx ] Serv ice Gan tri es 3 Copy ri ght © 200 4 S ie m ens 0019 43 07- 02 Is su e 1 1/ 2004 3-11  Install the m agnetic s trip (1) . Make sure the re is a g ap of 0.8 m…

Service

Gantries

SIPLACE HF-Series

Replacing the Gantry [03006781-xx]

3-10



With the aid of a 1/100 plastic thickness gauge, check the gap

between the portal contact edge and the guide slide (1). The

gantry must lie flush with the guide slide, leaving no room in-

between for the thickness gauge.



If this is not the case, dismantle the gantry and clean the

contact surfaces again thoroughly (with the dressing stone).

SIPLACE HF-Series

Replacing the Gantry [03006781-xx]

Service

Gantries



Install the magnetic strip (1).

Make sure there is a gap of 0.8 mm between two magnetic

strips.



Install the blue covers.



Install the cover plate for the magnet.



Install the trailing cable.



Install the PCB camera.



Reconnect to the electrical and pneumatic systems.



Fasten all electrical leads and pneumatic hoses at the correct

points.



Install all dismantled modules, covers and cover plates.

Service

Gantries

SIPLACE HF-Series

Replacing the Trailing Cable [03013940-xx]

3-12

3.1.2 Replacing the Trailing Cable [03013940-xx]

Parts

 Trailing cable for HF 3 (gantry 1 or 3) [03013642-xx]

 Trailing cable for HF (gantry 4) [03013940-xx]

Preparation

The trailing cable is supplied as a fully assembled module. Depending upon the configuration of the machine, you will

need to remove the relevant modules, covers and cover plates before you can dismantle the trailing cable.

 Where necessary, remove the cover plates from the gantry

trailing cable. Mark their exact position to ensure correct

replacement later.



Remove the top central cover from the SIPLACE machine.



Remove the top EMC plate.



Remove the upright EMC plates so that you can reach the

trailing cable.