Anleitung X2 SP 1 und 3.pdf - 第15页
Special Design 2 Assembly instructions Special des ign for manual tray on X2 at location 1 or 3 04/2007 Edition 15 2 Assembly instructions S pecial design for manual tray on X2 at location 1 or 3 2.1 W orking principle O…
1 Montageanleitung SOKO Manuelles Tray an X2 an Stellplatz 1 oder 3 SOKO
Ausgabe 04/2007
14
Special Design 2 Assembly instructions Special design for manual tray on X2 at location 1 or 3
04/2007 Edition
15
2 Assembly instructions
Special design for manual tray on X2
at location 1 or 3
2.1 Working principle
On an X2 it is possible to place a JEDEC tray inside the machine. 2
2.2 Requirements
2.3 Restrictions
The tray holder is intended solely for components that, including the tray, do not exceed: 2
– 0 mm to 13.5 mm (if two contact plates are installed)
– 3.5 mm to 16 mm (if one contact plate is installed)
in height. 2
If different components are to be placed on this tray holder, they must be no higher than this, oth-
erwise there is a risk of crashing with the head. 2
If a service tool is used, the machine must be set up with the standard set-up once more. 2
– Only a limited performance calculation is possible.
– Segment 2 of the TwinHead may not be able to reach every component in the tray, depending
where the tray holder / tray is positioned.
2
2
The restrictions concerning the component range still apply. 2
2
Hardware:
SIPLACE X2 with component trolley HF (S tables)
Software: SIPLACE Pro 3.0 or later
Station software >=601
2 Assembly instructions Special design for manual tray on X2 at location 1 or 3 Special Design
04/2007 Edition
16
2.4 Deliverables
– Tray holder for location 1 or 3 (for 1 JEDEC tray)
– 2 hexagon socket head screw M5 X 12 mm for tray holder
– 2 magnets for fixing the tray
– Carrier for second nozzle changer (03005337-xx)
– 1 Counter-sunk screw M5 x 12 mm
– 2 Adjust pins
Ø M6 x 14 mm
– 4 supports for nozzle changers 2.5 mm (03021044-xx)
– Programming guide for arbitrary carrier under SIPLACE Pro (00194607-xx)
– Assembly instructions for tray holders (00195382-xx).
2.5 Tools and consumables required
– Hexagon socket spanners, set
– Diagonal cutter
– Spirit level.
2