00195397-01_Installation Manual Setup Center 2.3 - 第65页
Installation Scanner Configuration Steps to perform after Installation Installation Manual SIPLACE Setup Center 2.3 65 By first configuration the cradle is unknown for Setup Center. X Validate the mess age with “ Yes ” t…
Installation
Steps to perform after Installation Scanner Configuration
64 Installation Manual SIPLACE Setup Center 2.3
X Open the setting dialog for scanner in Setup Center configuration.
X Click “Connect scanner…” to begin.
By first configuration of a scanner by this Setup Center, the cradle address is set by random.
X Click the barcode trigger-key on scanner one time to activate it from standby-mode.
X Put the scanner into the cradle and click “Start” to set up the scanner.
NOTE:
If the button is disabled, Setup Center was not able to detect a cradle on startup.
X In this case, ensure the connection to a serial port and restart Setup Center.
X Alternatively you can manually change the port, where the cradle is connected, by removing
the “Autodetect” checkbox.
After changing, click “Apply” to take over the new port.
Click “Connect Scanner…” to continue.
Installation
Scanner Configuration Steps to perform after Installation
Installation Manual SIPLACE Setup Center 2.3
65
By first configuration the cradle is unknown for Setup Center.
X Validate the message with “Yes” to continue.
X Remove the scanner from cradle and press the “Enter”-key on scanner to check the connection to
Setup Center.
X Click “Yes” to connect another scanner with Setup Center.
X The scanner-ID is now incremented to the next unused address. Activate the next Scanner from
standby, put it into cradle and click “Start”.
If you manually enter an already used address, Setup Center will warn you by following.
ATTENTION:
Configure each scanner again, if you moved the cradle from another Setup Center computer.
ATTENTION:
Do not scan or press keys at an already connected scanner, while configuring a new one.
Installation
Steps to perform after Installation Scanner Configuration
66 Installation Manual SIPLACE Setup Center 2.3
Changing the cradle address
If you want to change the cradle address in the future, you should notify that all previously connected
scanners will be disconnected. You have to reconfigure them again.
X Click “Start” to continue.
X Click “Yes” to confirm the change.
ATTENTION:
Make sure that the cradle address is unique in a factory.
ATTENTION:
It’s not recommended to move a cradle from one Setup Center Computer to another. In this
case, please configure each scanner again.