00197490-03_SM_CP20-P-M2_EN保养维护 - 第38页
4 Component camera, Z axis and component sensor 4.5 Replacing the component sensor 38 Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 Installation ► Fix the new component sensor with the two fasteni…
4 Component camera, Z axis and component sensor
4.5 Replacing the component sensor
Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 37
Removal
Fig.41: Pulling the cover off
► Pull the cover(1) off the intermediate distributor.
The cover is fixed by four press studs on the stay
bolts.
NOTICE!
Older heads may not have this cover yet.
.
► Dismantle the Z axis cover.
4.2 "Replacing the Z axis cover" [}29]
You can now access the component sensor.
Fig.42: Electrical connection
► Unplug the electrical connection(1) from the
component sensor.
Remove any cable ties. You may want to mark
their positions for easier exact replacement later
on.
Fig.43: Fastening screws
► Remove the two screws(1) fastening the compo-
nent sensor(2) and then remove the component
sensor.
4 Component camera, Z axis and component sensor
4.5 Replacing the component sensor
38 Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018
Installation
► Fix the new component sensor with the two fastening screws.
► Plug in the electrical connection. Fasten the cable with cable ties, if required.
► Follow the removal instructions in reverse order for further installation.
Also observe the installation instructions in the following section:
4.2 "Replacing the Z axis cover" [}29]
► Observe in particular the torques specified!
► Calibrate the component sensor.
11.2.1 "Calibrating the heads and cameras (SW70x)" [}84]
5 DP drives
5.1 Replacing the DP drive
Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 39
5 DP drives
5.1 Replacing the DP drive
Parts
Fig.44: DP drive (example of SIPLACE C&P20P shown)
Select the correct DP drive:
●
For SIPLACE C&P20P:
DP drive SIPLACE C&P20P [03102532Sxx] (in-
cluding accessories)
●
For SIPLACE C&P20M2:
DP drive SIPLACE C&P20M2 assembly
[03153682Sxx] (including accessories)
●
If needed: DP vacuum hose for SIPLACE C&P20P [03103784‑xx]
Overview
Fig.45: DP drive (example of SIPLACE C&P20P shown)
1. Board
2. Connection for compressed air supply
3. Linear guide
4. End stop edge
5. Fastening screw
6. Fastening screw
Fig.46: DP change tool
●
DP change tool for the SIPLACE C&P20P
[03109065‑xx]
The DP change tool makes it easier to fit the DP drive
in the placement head.