00197490-03_SM_CP20-P-M2_EN保养维护 - 第40页

5 DP drives 5.1 Replacing the DP drive 40 Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 Torques Fig.47: Clamping plate fastening screw 1. Clamping plates 2. Screw fastening the clamping plate Tor…

100%1 / 88
5 DP drives
5.1 Replacing the DP drive
Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 39
5 DP drives
5.1 Replacing the DP drive
Parts
Fig.44: DP drive (example of SIPLACE C&P20P shown)
Select the correct DP drive:
●
For SIPLACE C&P20P:
DP drive SIPLACE C&P20P [03102532Sxx] (in-
cluding accessories)
●
For SIPLACE C&P20M2:
DP drive SIPLACE C&P20M2 assembly
[03153682Sxx] (including accessories)
●
If needed: DP vacuum hose for SIPLACE C&P20P [03103784‑xx]
Overview
Fig.45: DP drive (example of SIPLACE C&P20P shown)
1. Board
2. Connection for compressed air supply
3. Linear guide
4. End stop edge
5. Fastening screw
6. Fastening screw
Fig.46: DP change tool
●
DP change tool for the SIPLACE C&P20P
[03109065‑xx]
The DP change tool makes it easier to fit the DP drive
in the placement head.
5 DP drives
5.1 Replacing the DP drive
40 Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018
Torques
Fig.47: Clamping plate fastening screw
1. Clamping plates
2. Screw fastening the clamping plate
Torque: 0.1Nm
Preparation
► Remove the head from the machine. For details about removing and fitting the placement
head, refer to the service manual for your machine.
Fit the head on the head mount [03056231‑xx].
► Make sure that the component sensor protective cap is fitted.
1.1.3 "Safety instructions for the component sensor" [}6]
Removal
CAUTION
Tweezers, blunt 145mm size 3mm [00376493-xx]
Do not use any other tweezers for the hoses. If you do, the hoses could be damaged.
► Dismantle the holding circuit/aperture ring.
7.1 "Replacing the holding circuit/reflecting ring" [}61]
► Pull the nozzle off the segment.
Fig.48: Clamping plates
► Remove the screws(2) fastening the clamping
plates(1), on the right and left of the relevant DP
drive and take off the clamping plates.
5 DP drives
5.1 Replacing the DP drive
Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 41
Fig.49: Board
► Carefully pull the board (1) off the connector (2).
Fig.50: Star carrier
► Remove the two screws (2) fastening the relevant
DP drive (1) to the inside of the star carrier.
 CAUTION!
Take care not to lose the screws.
.
Fig.51: Hose
► Disconnect the hose (2) from the DP drive (1).
► (3) Remove the DP drive through the service
opening.