00197490-03_SM_CP20-P-M2_EN保养维护 - 第77页

9 Intermediate distributor 9.1 Replacing the intermediate distributor board Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 77 9 Intermediate distributor 9.1 Replacing the intermediate distributor b…

8 Return unit and return cylinder

8.3 Replacing the driver lever

76 Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018

Installation

► Fit the driver lever fully onto the return cylinder pin and then tighten the fastening screw with a

torque of 1.15 Nm.

Make sure that the return cylinder, the holder and the driver lever are all parallel.

► If you dismantled the return unit, continue with further installation as described there (see 8.1

"Replacing the return unit" [}71]).

If not, perform the following steps:

Fig.117: Inspection checks

► Perform the following checks:

●

The driver lever must lie against the Z axis.

●

Check that the star can be revolved.

●

Check the distance(A) between the driver

lever(1) and the rotor(2) of the Z motor. The dis-

tance should be approx. 0.5 mm when the Z axis

is pushed upwards.

► If there are any problems, go through the afore-

mentioned steps again.

► Follow the removal instructions in reverse order for further installation.

9 Intermediate distributor

9.1 Replacing the intermediate distributor board

Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018 77

9 Intermediate distributor

9.1 Replacing the intermediate distributor board

Parts

●

For SIPLACE C&P20P: intermediate distributor board assembly SIPLACE C&P20P

[03110751Sxx]

●

For SIPLACE C&P20M2: intermediate distributor assembly SIPLACE C&P20M2

[03124689Sxx]

Overview

Fig.118: Overview of intermediate distributor 1

1. Intermediate distributor board assembly

SIPLACE C&P20P [03110751-xx]

2. Four fastening bolts

Fig.119: Overview of intermediate distributor 2

Intermediate distributor board assembly SIPLACE

C&P20P [03110751-xx]

Preparation

► Although this work can be performed in the machine, you might find it advisable to remove the

head so that you have better access to it.

For details about removing and fitting the placement head, refer to the service manual for your

machine.

In this case, fit the head on the head mount [03056231‑xx].

► Make sure that the component sensor protective cap is fitted when outside the machine.

9 Intermediate distributor

9.1 Replacing the intermediate distributor board

78 Service Manual SIPLACE SpeedStar (C&P20 P / C&P20 M2) 03/2018

Removal

Fig.120: Pulling the cover off

► Pull the cover(1) off the intermediate distributor.

The cover is fixed by four press studs on the stay

bolts.

 NOTICE!



Older heads may not have this cover yet.

Fig.121: Dismantling the intermediate distributor board

► Unplug all electrical connections. Mark their posi-

tions to make clear assignment easier later on.

Take particular care not to confuse the two board

connectors(1).

► Remove the four screws fastening the intermedi-

ate distributor and then take off the intermediate

distributor.

Installation

► Follow the removal instructions in reverse order for installation. Also observe the following

instructions:

NOTICE

Installation instructions

Transfer the machine data to the EPROM!

► Transfer the machine data from the station to the intermediate distributor. For more in-

formation about this read section 11.3 "Transferring the head specific data (from

SW701)" [}86].