00198608-02_SM_CP20P2_Kunde_EN - 第15页
3 Component camera, Z axis and component sensor 3.1 Replacing the Component Camera Service Manual SIPLACE SpeedStar (C&P20 P2) 01/2019 15 Fig.8: Screws fastening the component camera ► Remove the four fastening scre…
3 Component camera, Z axis and component sensor
3.1 Replacing the Component Camera
14 Service Manual SIPLACE SpeedStar (C&P20 P2) 01/2019
Preparation
► Remove the head from the machine. For details about removing and fitting the placement
head, refer to the service manual for your machine.
Fit the head on the head mount [03056231‑xx].
CAUTION
Do not damage or contaminate the camera lens system.
► Make sure that you do not damage or contaminate the camera lens system.
► Make sure that the component sensor protective cap is fitted.
1.1.3 "Safety instructions for the component sensor" [}6]
Removal
Fig.6: Pulling the cover off
► Pull the cover(1) off the intermediate
distributor.
The cover is fixed by four press studs
on the stay bolts.
Fig.7: Camera cable
► Loosen the cable ties(1).
3 Component camera, Z axis and component sensor
3.1 Replacing the Component Camera
Service Manual SIPLACE SpeedStar (C&P20 P2) 01/2019 15
Fig.8: Screws fastening the component camera
► Remove the four fastening screws(2)
(Allen 2.5).
► Carefully pull the component camera
(1) off the locating pins.
Installation
Fig.9: Cables
► Fit the new component camera with
four screws (Allen 2.5, M3x16, torque
1.3Nm).
► Pay attention to how the cables are run
and fasten them with cable ties(1).
► Follow the removal instructions in reverse order for further installation.
► Calibrate the placement head after installation.
If this is not the case, brief calibration will not be suggested and standard calibration must be
performed.
3 Component camera, Z axis and component sensor
3.1 Replacing the Component Camera
16 Service Manual SIPLACE SpeedStar (C&P20 P2) 01/2019
3.1.1 Board: Vision LED controller VLC48
03146613-xx Vision LED controller VLC48
This circuit board is fitted in the following component cameras:
03131695‑xx Component camera C&P (type 48) 8x8 GigE
Fig.10: Camera type 48 – board front