00197295-01_UM_D4i_SR605_EN - 第133页
User manual SIPLACE D4i 3 Technical data for the machine From software version SR.605.03 SP2 10/2012 EN edition 3.10 Component trolley 133 PLEASE NOTE: 3 At external set-up positions, yo u will need an extern al power su…
3 Technical data for the machine User manual SIPLACE D4i
3.10 Component trolley From software version SR.605.03 SP2 10/2012 EN edition
132
3.10 Component trolley
Item no. 00119821-xx CO trolley HS feeder, D4i
Up to four component trolleys can be docked into SIPLACE D4i machines. The locations are num-
bered as shown in the diagram below.
3
Fig. 3.10 - 1 Locations for the component trolleys
(1) Location 1
(2) Location 2
(3) Location 3
(4) Location 4
(T) PCB direction of travel
The component trolleys are stand-alone modules that can be set up with feeders at an external
set-up area. This means that the production process only has to be interrupted briefly in order to
change the component trolley.
User manual SIPLACE D4i 3 Technical data for the machine
From software version SR.605.03 SP2 10/2012 EN edition 3.10 Component trolley
133
PLEASE NOTE: 3
At external set-up positions, you will need an external power supply for the component trolley
(see Section 3.10.5, page 137).
3
Fig. 3.10 - 2 Component trolley with a PCB conveyor height of 950 mm
3
(1) Holes for the conveyor heights of 830 to 950 mm
(2) Component table
Properties
– The trolleys move easily.
– The component trolley is fixed so precisely to the machine that it is even suitable for process-
ing 01005 components.
– The component trolley can be adjusted to PCB conveyor heights of 830 mm, 900 mm, 930
mm and 950 mm in just a few simple actions.
– The tape container can hold tape reels with a diameter of up to 15" (optional up to 19").
3 Technical data for the machine User manual SIPLACE D4i
3.10 Component trolley From software version SR.605.03 SP2 10/2012 EN edition
134
3.10.1 Structure
The component trolley essentially consists of the chassis, the component table for holding the
feeder modules, the communication unit, tape reel container and the waste container.
Fig. 3.10 - 3 Component trolley: front and back view
(1) Chassis
(2) Tape reel container
(3) Handle
(4) Waste tape container
(5) Communication unit
(6) Component table
(7) Button for lowering the component table
3.10.2 Description
The chassis (item 1 in Fig. 3.10 - 3) runs smoothly and is easy to maneuver.
The component table (item 6 in Fig. 3.10 - 3
) has a capacity of up to 12 locations for 30 mm wide
feeder modules. The feeder modules are mechanically centered on the table using centering pins
and centering balls. The bulk case feeder modules are supplied with compressed air via a sepa-
rate compressed air bar.
The interface is connected to the machine using a cable. The power supply, communication and
EMERGENCY STOP circuits are routed via this cable. The compressed air supply for the bulk
case feeder module and the lifting mechanism also pass via this interface.