OM-1606-006w_GT-28x.pdf - 第120页
OM-1606 6-18 6. Splicing 0908-001 6.6.4 Precautions (1) When the carrier tape is cut or spliced, take care so that the component feed pitch does not slide. Otherwise, the pick-up error might occur . (2) Cut and splice th…
OM-1606
6. Splicing
6-17
Peel off the white peeling paper on
the other backing tape.
Adhere the backing tape to the rear
side (embossed bottom surface)
of the cover tape so that the joint
position is located at the center.
Peel off the transparent lm.
Conrm that the splicing tape has
been adhered securely to the cover
tape and the carrier tape surfaces.
When the tape has been spliced
securely, the procedure is completed.
0908-001
6
7
8
9
OM-1606
6-18
6. Splicing
0908-001
6.6.4 Precautions
(1) When the carrier tape is cut or spliced, take care so that the
component feed pitch does not slide.
Otherwise, the pick-up error might occur.
(2) Cut and splice the carrier tape so that there is no gap, overlap or
deviation of the carrier tape on the joint position.
Cut the tape at an angle of 90 degrees to the long side and at the
same position, based on the sprocket hole.
If there is any gap, overlap or deviation, a feed error might occur.
Gap
Overlap
Deviation
OM-1606
6. Splicing
6-190908-001
(3) When the splicing tape is adhered, set the center of the cut position of
the splicing tape.
If the tape is deviated along the direction of the splicing tape, the tape
joint section might come off.
Positional Deviation
(4) Do not let the splicing tape swell very far out from the carrier tape.
If there is any swell out, a feed error might occur.