OM-1606-006w_GT-28x.pdf - 第125页

OM-1606 6. Splicing 6-23 Peel off the transparent lm. Peel off the white peeling paper on the splicing tape which has been cut in Step 1 . Adhere it to the rear side (embossed bottom surface) of the cover tape so that t…

OM-1606

6-22

6. Splicing

6.7.3 Tape Splicing Procedure (For 24 mm or more : FC24QE)

Note

When part of black tape is left on the peeling paper, return the peeling

paper and press the tape against the paper. Then, peel off the peeling paper

again.

Cut off the splicing tape along the

perforations.

Peel off the white peeling paper on

the splicing tape.

First, adhere the cover tape surface

of the new tape onto the splicing

tape.

Align the tape border on the opposite

side of the sprocket hole with the

reference guide, and so adhere it

that the joint position is located at the

center.

Adhere the cover tape surface on the

feeder.

Align the tape border on the opposite

side of the sprocket hole with the

reference guide, and so adhere it that

there is no gap on the joint position

with the new tape.

Bend the splicing tape along the

perforations and adhere it onto the

carrier tape on the sprocket hole

border side.

In order to adhere the splicing tape

securely, press and rub the surface

of the transparent tape entirely.

0908-001

OM-1606

6. Splicing

6-23

Peel off the transparent lm.

Peel off the white peeling paper on

the splicing tape which has been cut

in Step 1 .

Adhere it to the rear side (embossed

bottom surface) of the cover tape so

that the joint position is located at the

center.

Peel off the transparent lm.

Conrm that the splicing tape has

been adhered securely to the cover

tape and the carrier tape surfaces.

When the tape has been spliced

securely, the procedure is completed.

0908-001

OM-1606

6-24

6. Splicing

0908-001

6.7.4 Precautions

(1) When the carrier tape is cut or spliced, take care so that the

component feed pitch does not slide.

Otherwise, the pick-up error might occur.

(2) Cut and splice the carrier tape so that there is no gap, overlap or

deviation of the carrier tape on the joint position.

Cut the tape at an angle of 90 degrees to the long side and at the

same position, based on the sprocket hole.

If there is any gap, overlap or deviation, a feed error might occur.

Gap

Overlap

Deviation