OM-1606-006w_GT-28x.pdf - 第131页
OM-1606 6. Splicing 6-29 Peel off the transparent lm. Peel off the white peeling paper on the splicing tape which has been cut in Step 1 . Adhere it to the rear side (embossed bottom surface) of the cover tape so that t…
OM-1606
6-28
6. Splicing
6.8.3 Tape Splicing Procedure (For 24 mm or more : FC24QE)
Note
When part of black tape is left on the peeling paper, return the peeling
paper and press the tape against the paper. Then, peel off the peeling paper
again.
Cut off the splicing tape along the
perforations.
Peel off the white peeling paper
on the splicing tape up to the
perforations and bend it.
First, adhere the cover tape surface
of the new tape onto the splicing
tape.
Align the bent perforations with the
tape border of the sprocket hole side
and so adhere it that the joint position
is located at the center.
Adhere the cover tape surface on the
feeder.
Align the bent perforations with the
tape border of the sprocket hole side
and so adhere it that there is no gap
on the joint position with the new
tape.
Peel off the peeling paper, bend the
splicing tape along the perforations
and adhere it onto the carrier tape on
the sprocket hole border side.
In order to adhere the splicing tape
securely, press and rub the surface
of the transparent lm entirely.
0908-001
1
2
3
4
5
OM-1606
6. Splicing
6-29
Peel off the transparent lm.
Peel off the white peeling paper on
the splicing tape which has been cut
in Step 1 .
Adhere it to the rear side (embossed
bottom surface) of the cover tape so
that the joint position is located at the
center.
Peel off the transparent lm.
Conrm that the splicing tape has
been adhered securely to the cover
tape and the carrier tape surfaces.
When the tape has been spliced
securely, the procedure is completed.
0908-001
6
7
8
9
10
OM-1606
6-30
6. Splicing
0908-001
6.8.4 Precautions
(1) When the carrier tape is cut or spliced, take care so that the
component feed pitch does not slide.
Otherwise, the pick-up error might occur.
(2) Cut and splice the carrier tape so that there is no gap, overlap or
deviation of the carrier tape on the joint position.
Cut the tape at an angle of 90 degrees to the long side and at the
same position, based on the sprocket hole.
If there is any gap, overlap or deviation, a feed error might occur.
Gap
Overlap
Deviation