OM-1606-006w_GT-28x.pdf - 第137页

OM-1606 6. Splicing 6-35 6.9.3 T ape Splicing Procedure (For 24 mm or more : FC24QE) Note When part of black tape is left on the peeling paper , return the peeling paper and press the tape against the paper . Then, peel …

OM-1606

6-34

6. Splicing

0908-001

6.9.2 Cutting Tape on Feeder Side

(1) Prepare the tape on the feeder side.

(2) Cut the tape on the feeder side.

Set the tape on the pilot pins and cut

it.

•

The tape cut jig can deal with tape

with up to 32 mm in width. Cut it

twice.

Otherwise, use scissors if available

and cut it so that the cut position is

not deviated.

•

Take care not to cut any component

in order to prevent damage to the

tape cutting jig.

•

In the case of 12 mm, 20 mm, 28 mm

or 36 mm pitch, the pilot pins are not

used.

(3) The preparation of the tape on the

feeder side has been completed.

If it tends to bend, correct it.

•

In the case of 12 mm, 20 mm, 28

mm or 36 mm pitch, do not use the

pilot pins. Cut the tape at the center

position between the two carrier

pockets.

Cut the tape so that the carrier tapes

are not overlapped each other at the

joint section.

Feeder Side

Section where the

components are

not included

Section where the

components are included

Cut Position

OM-1606

6. Splicing

6-35

6.9.3 Tape Splicing Procedure (For 24 mm or more : FC24QE)

Note

When part of black tape is left on the peeling paper, return the peeling

paper and press the tape against the paper. Then, peel off the peeling paper

again.

Cut off the splicing tape along the

perforations.

Peel off the white peeling paper

on the splicing tape up to the

perforations and bend it.

First, adhere the cover tape surface

of the new tape onto the splicing

tape.

Align the folded perforations with the

tape border of the reference sprocket

hole side and so adhere it that the

joint position is located at the center.

Adhere the cover tape surface on the

feeder.

Align the folded perforations with the

tape border of the reference sprocket

hole side and so adhere it that there

should be no gap on the joint position

with the new tape.

Peel off the peeling paper, fold the

splicing tape along the perforations

and adhere it to the carrier tape on

the reference sprocket hole border

side.

In order to adhere the splicing tape

securely, press and rub the surface

of the transparent lm entirely.

0908-001

OM-1606

6-36

6. Splicing

Peel off the transparent lm.

Cut off the other splicing tape the

same as shown in Step 1 .

Peel off the white peeling paper up to

the perforations and fold it as shown

in Step 2

Adhere the splicing tape also onto

the slave sprocket holes.

Align the folded perforations with the

tape border of the slave sprocket

holes and so adhere that there are

no gaps on the joint position with the

other tape.

Peel off the peeling paper, fold the

splicing tape along the perforations

and adhere it to the carrier tape on

the slave sprocket hole border side.

In order to adhere the splicing tape

securely, press and rub the entire

surface of the transparent lm.

0908-001