OM-1606-006w_GT-28x.pdf - 第162页

OM-1606 7-12 7. Maintenance 7.5 Maintenance Method 7.5.1 How to Apply Grease to the Sprocket Driving Gear Unit Procedure (1) Open the right side cover . Remove the set screw (countersunk head screw) on 7 locations and op…

100%1 / 235
OM-1606
7-11
7. Maintenance
7.4.6 Tape Feed Gear Section
Worm Gear
Every Three Months Cleaning, Lubrication
Remove the dust protective cover and remove dust and debris using a cloth
or bamboo probe. Then, apply MOLYNOC Grease AP1 using the greasing jig.
Greasing Jig
Refer to "7.5.1 How to Apply Grease to the Sprocket Driving Gear
Unit" for details.
Reference
FG10
7.4.7 Cover Tape Take-up Gear Section
Flat End Wheel, Worm Gear, Worm Wheel (Right Side, Left Side)
Every Three Months Cleaning, Lubrication
Remove the cover and remove dust and debris using a cloth or bamboo probe.
Then, apply MOLYNOC Grease AP1 using the greasing jig.
Flat End Wheel
Worm Gear
The illustration shows the left side of the unit.
However, apply the same procedure also
to the right side of the unit.
Worm Wheel
Cover
FG11
0908-001
OM-1606
7-12
7. Maintenance
7.5 Maintenance Method
7.5.1 How to Apply Grease to the Sprocket Driving Gear Unit
Procedure
(1) Open the right side cover.
Remove the set screw (countersunk head screw) on 7 locations and open the
right side cover to expose the right sprocket.
In the right sprocket section, the dust preventive cover made of transparent
resin is attached as shown in the following gure.
Right Sprocket
Dust Preventive Cover
(Transparent)
Right Side Cover Set Screw
(Countersunk Head Screw)
on 7 locations
FG12
0908-001
OM-1606
7-13
7. Maintenance
(2) Remove the dust preventive cover.
Remove the dust preventive cover to expose the right worm gear.
Dust Preventive Cover
Projected Section
FG13
For the removal of the cover, after the two projected sections (shown as
white circles in the above gure) are removed, it can be removed by means
of pulling it down.
Note
Take care of handling the dust preventive cover so that it is not damaged
when it is attached or removed.
(3) Apply grease on the right worm gear and wheel.
Apply grease directly on the right worm gear and wheel using the greasing
jig (The amount to be applied should be about 0.2 ml (two divisions on the
gauge)).
Right Worm Wheel
Greasing Jig
Right Worm Gear
FG14
0908-001