OM-1606-006w_GT-28x.pdf - 第223页

OM-1606 1 1-2 1 1. T roubleshooting Remedy : Remove any chip component or foreign substance such as debris attached on the suppressor and completely clean the suppressor . If the taping component is mounted with any fore…

OM-1606

11-1

11. Troubleshooting

The main troubleshooting during the tape feeder operation is described here.

In the event of trouble, con rm in which section the trouble is caused and set it

right.

11.1 Component Pick-up Error

Remedy

: Align the chip component center with the marks on the suppressor according to "5.

Component Pick-up Position Alignment".

Marks on the Suppressor

If the component center is not aligned with the pick-up position, then the pick-up cannot

proceed correctly.

Cause : Inappropriate pick-up positioning

Notice

Remedy

: Adjust the pick-up position by using the feeder adjusting jig JG-0209

(Purchase separately).

Pick-up Position

If the component center is not aligned with the pick-up position, then the pick-up cannot

proceed correctly.

Cause : Error in Pick-up Position

Notice

0908-001

OM-1606

11-2

11. Troubleshooting

Remedy

: Remove any chip component or foreign substance such as debris attached on the

suppressor and completely clean the suppressor.

If the taping component is mounted with any foreign substance attached, the suppresser

might be deformed or a pick-up error occur.

Therefore, clean it.

Cause : Chip component has become attached inside the suppressor and

moves wild.

Chip component or foreign

substances including debris

Notice

1005-002

Remedy

: Clean the vacuum nozzle on the main machine of SIGMA-G4/G5 according to

"Volume 4: Maintenance and Troubleshooting" in the Instruction Manual for

SIGMA-G4/G5 main machine.

If the factory is dusty or if paper taping component is often used, then the vacuum nozzle and vacuum

nozzle lter can easily become dirty.

Keep them clean.

Cause : Dirty Vacuum Nozzle

Clogged Vacuum Nozzle Hole

Dirty Vacuum Nozzle Filter

Note

OM-1606

11-3

11. Troubleshooting

0908-001

11.2 Tape Feeder not correctly locked

Remedy

: Remove any chip component or foreign substance such as debris attached on the

feeder base and completely clean the feeder base.

If the tape feeder is used while it has not been locked, it might cause damage to the machine or pick-

up error.

Attach the tape feeder securely to the feeder base.

Cause : Chip component or foreign substances including debris have been

attached onto the feeder base.

Note