OM-1606-006w_GT-28x.pdf - 第43页
OM-1606 2. Attachment and Detachment of T ape 2-1 1 • Cleaning of Suppressor Fulcrum Point Chip components which scatter during the tape cassette setup operation and enter inside the suppressor from the gap between the …
OM-1606
2-10
2. Attachment and Detachment of Tape
(13) Press down the cover tape take-up release lever, insert the end of the cover
tape into the cover tape housing section, and reset the cover tape take-up
release lever.
Notice
•
It should be conrmed that there is not anything sticking, or any
twist or knot of the cover tape.
•
Take care so that your nger is not caught by the take-up gear.
Cover Tape Housing Section
Cover Tape Take-up Release Lever
Cover Tape
Hold the end of the cover tape between fingers
as shown in the figure and insert it into the cover tape
housing section.
Take-Up Gear Section
FB15
(14) Select the lane to be used using the lane selection button on the operation
panel and press the take-up button to send the cover tape to the cover tape
housing section.
Press the take-up button, continuously, until the take-up gear is stopped
automatically.
Reference
Refer to "4. Operation Panel" for operation panel.
0908-001
OM-1606
2. Attachment and Detachment of Tape
2-11
•
Cleaning of Suppressor Fulcrum Point
Chip components which scatter during the tape cassette setup operation and
enter inside the suppressor from the gap between the suppressor and the chute,
might be accumulated at the suppressor fulcrum point (between the chute under
the suppressor and the body).
Accumulated chip components around this area hinder the suppressor opening
or closing operation, so clean this area diligently.
Reference
Refer to "7.4.4 Component Discharging Section" for the details of
maintenance.
0908-001
OM-1606
2-12
2. Attachment and Detachment of Tape
1005-001
2.2 Cover Tape Tension Loosening Procedure
In the case that there is any joint of the splicing tapes in the cover tape take-up
route and the cover tape is tensed for a long time, the joint of the splicing tapes
deviates and the cover tape easily peels off. In such cases, loosen the cover tape
tension using the following procedure.
(1) Hold the roller section on the tension lever.
(2) Press the take-up releasing lever and return the tape.
(3) When the tape is begins to return,
return the tension lever.
FB15-1
Procedure
(1) Hold the roller section (on the rear side) of the tension lever lightly from the
upper direction with your nger.
(2) Press down the take-up releasing lever and return the taken up cover tape.
(3) Return the stopper of the tension lever so that the cover tape is not loosened
too much, and return the cover tape.