00195334-01 - 第21页
HS-50 transport contr oller 2 Retrofit instructions internal C onveyor control TSP200 in machine no .: 1-20 SIPLACE HS-50 08/2000 Edition 21 : Mark the drilling position s with the prick punch. : Drill, countersink and t…
2 Retrofit instructions internal Conveyor control TSP200 in machine no.: 1-20 SIPLACE HS-50 HS-50 transport controller
08/2000 Edition
20
2.6 Attaching the TSP in sector 1
: Use the base plate as a drilling template and mark the drilling positions.
2
: Cover the area around the sector well to prevent steel swarf reaching the cable duct.
2
240 mm
340 mm
250 mm
HS-50 transport controller 2 Retrofit instructions internal Conveyor control TSP200 in machine no.: 1-20 SIPLACE HS-50
08/2000 Edition
21
: Mark the drilling positions with the prick punch.
: Drill, countersink and tap the thread.
: Remove the drilling cover.
: Screw the TSP200 firmly in place.
2
2
: Detach the power supply from the old conveyor control.
: Connect the power supply cable using connector X79 (cable comes from the main distribution
board, connector xdo8).
: Detach the power supply from the SLIO modules and remove connector xdo7 from the main
distribution board (no longer needed).
: Connect the grounding cable to the machine frame.
2
2
2
2
2 Retrofit instructions internal Conveyor control TSP200 in machine no.: 1-20 SIPLACE HS-50 HS-50 transport controller
08/2000 Edition
22
: Unplug the CAN bus cable from the old conveyor control and SLIOs and connect the cable to
the new conveyor control as follows:
Connect the last connector (X18am) to the Conveyor 1 terminal (X22ao) and connector
(x34ao) to the Conveyor 2 terminal (X22ap).
2
2
: Detach connectors X3am/X6am (or X3an/X6an on the dual conveyor) from the SLIOs and pull
them through the machine to the new conveyor control.
2