00196932-02 SM S-Feeder Repair DE EN multilang - 第105页

5 Checking and adjusting 2x8mm S-Feeder 5.3 Current input and direction of rotation at the cover strip disposal motor SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 105 8. Plug the adapter ca ble to slot 2 . 9. Tur…

5 Checking and adjusting 2x8mm S-Feeder

5.3 Current input and direction of rotation at the cover strip disposal motor

104 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur

5.3

5.3 Current input and direction of rotation at the cover strip disposal motor

Current input and direction of rotation at the cover strip disposal

motor

5. Bring the 5/30V switch to the upper position (5V the

switch position 30V represents a possible endurance test

available .. Put on the switch 1 in "Foil motor on" (upper

position), the corresponding green LED is lighting.

6. Change the play of the shaft to pin wheel by manually

housing, carefully through cautiously placing a screwdriv

er under the motor casing.

7. If the test box indicates 50 + / - 3mA, the gear is set

correctly.

8. Exactly in this position, fasten the “housing, complete”

using the two allen screws.

Switch off S1 again and unplug the connector of the mo

tor cable from the adapter cable.

1. Connect the motor to the adapter cable

2. Plug the other end of the adapter cable on the connec

tor 1 of the extension box.

3. Turn on the S-Feeder Motor Testbox.

4. Set the switch 5/30V to 5V. The switch position 30V is

suitable for endurance test.

5. Turn on the switch 1.

6. Check the current consumption. Reference is 5-10 mA.

7. Check that the motor rotates clockwise!

5 Checking and adjusting 2x8mm S-Feeder

5.3 Current input and direction of rotation at the cover strip disposal motor

SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 105

8. Plug the adapter cable to slot 2.

9. Turn on the switch 2 up

10. Check the current consumption. Reference is 5-10

11. Check that the motor rotates counter-clockwise.

CAUTION! With this test, no Feeders shall be

connected here to the test box!

5 Checking and adjusting 2x8mm S-Feeder

5.3 Current input and direction of rotation at the cover strip disposal motor

106 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur