00196932-02 SM S-Feeder Repair DE EN multilang - 第86页
3 S-Feeder Short Cir cuit Box 3.2 Testing the feeder 86 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 3.2 3 . 2 T e s t in g t h e f e e d e r Testing the feeder 1. Con nect the feede r mod ule (2) to the Siplace …
3 S-Feeder Short Circuit Box
3.1 Connection and self test
SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 85
3
3 S-Feeder Short Circuit Box
S-Feeder Short Circuit Box
3.1
3.1 Connection and self test
Connection and self test
1. Siplace S Feeder Test Box with socket for the feeder
2. Power supply
3. Base plate with earth connection for short-circuit test
4. Plug in the S-Feeder to the test box (1) and place the
feeder on the base plate with earth connection
5. Plug in at the rear side of the short circuit test-box the
cable of the base plate with earth connection to the sock
-
et "Ground".
6. Plug in the power supply to the socket "Power Input"
on the rear side of the short circuit.
7. Alternatively to the ground plane (3) You can also use
the "ground wire including terminal clip".
8. Connect it to the ground socket (5) on the rear side of
the short circuit test box (1). Connect the Terminal Clip to
the chassis of the feeder (4) .
3 S-Feeder Short Circuit Box
3.2 Testing the feeder
86 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur
3.2
3.2 Testing the feeder
Testing the feeder
1. Connect the feeder module (2) to the Siplace S-Feeder
short circuit test box (1) .
2. Make sure that the feeder is stable on the base plate
with earth connection (3).
3. Base plate with earth connection -> the terminal clip
can also be used as alternative with the terminal clip.
4. Turn the switch "Short Circuit Test" (4) upwards.
5. The green LED (5) lights up if there are no short cir
-
cuits.
The red LED indicates a short circuit and the feeder
needs to be checked and repaired before it is used again.
NOTICE
One or more feeders with short circuit can lead to overload the control and thus cause damage
to placement system.
➢ Therefore, do not set a feeder, where the red LED lights up.
► When switching the switch "Short Circuit Test" you will see a short red LED flash. If it im
-
mediately goes out, there is not a malfunction.
4 S-Feeder Test Software
4.1 Checking of 2x8mm S-Feeder
SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 87
4
4 S-Feeder Test Software
S-Feeder Test Software
4.1
4.1 Checking of 2x8mm S-Feeder
Checking of 2x8mm S-Feeder
1. Connect the power supply. and RS232 Cable with Mo
-
tortestbox (rear) ..
2. Connect the feeder with the Motortestbox (the picture
shows a 3x8mm S-Feeder).
3. Switch off the power supply and the motor testbox .
4. Connect the RS 232 cable to the PC through the
COM1 and start the test software
NOTICE
The subsequent procedure is described by the testing software for the 2x8mm S-Feeder
For operation can be used both of the function keys on the PC keyboard, as well as the corre
-
sponding buttons of the user interface!