00196932-02 SM S-Feeder Repair DE EN multilang - 第96页

4 S-Feeder Test Software 4.2 Checking of 3x8mm S-Feeder 96 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur F6 Displ ay 1. Start the test "Displ ay" with the key F6. 2. Please ch eck the display. All 7 segm…

4 S-Feeder Test Software

4.2 Checking of 3x8mm S-Feeder

SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 95

software workflow (3x8mmS feeder)

F5 Control panel

1. The left track is in the main menu after starting allways

enabled. Start the test "Operating panel" with the key F5.

2. Press the green touch key on the feeder. (Tape Index)

With this test will be tested the function of the 3 touch

key´s on the feeder - operator panel. The test is inde

pendent of the selected track.

3.Press the yellow touch key on the feeder (foil detail)

4. Press the blue foil taste on the feeder (track switch

over).

5. The Result is shown in the Comment field. The Test is

independent for each Track therefore repeat to complete

all

4 S-Feeder Test Software

4.2 Checking of 3x8mm S-Feeder

96 SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur

F6 Display

1. Start the test "Display" with the key F6.

2. Please check the display. All 7 segments on the 3 lo

cations and points need respectively flashing right on the

bottom.

3. Press the blue key on the feeder when all signals flash

correctly

4. The Result is shown in the Comment field.

4 S-Feeder Test Software

4.2 Checking of 3x8mm S-Feeder

SIPLACE S-Feeder Repair SIPLACE S-Förderer Reparatur 97

F7 cover strip

1. Start the test "cover strip" by pressing the key F7

2. Press the left rocker of the cover strip unit down.

Press the left rocker down as shown in the image until the

motor of the cover strip turns off . Release the rocker.

Press the other two rockers as shown in the following

steps 3 and 4.

3. Press the middle rocker down, till the cover strip turns

off, then release again.

4. Press the right rocker till the motor of the cover strip

turns off and release.

5. The Result is shown in the comment field and therefore

the test is finished.